JFW Industries, Inc. Phone: 317-887-1340 [email protected] www.jfwindustries.com SPECIFICATION SHEET JFW MODEL 75SA-092 SWITCH ASSEMBLY Frequency Range 5-1000 MHz Configuration 1P8T self-terminating solid-state RF switch Enclosure Type Benchtop Startup/Default States (configurable) RF switch OFF at startup (see SWITCH command) DHCP enabled (see NET command) 4 Ethernet users (see NET command) Prompts off (see PROMPT command) Impedance 75 Ohms nominal VSWR 1.2:1 typical / 1.4:1 maximum Insertion Loss 2.8 dB typical / 3.5 dB maximum Isolation 80 dB typical / 70 dB minimum RF Input Power +10 dBm +20 dBm Switching Speed 10 microseconds (after command is received and processed) (3 milliseconds typical processing time) Manual Control 20-Button Keypad and LCD display (IP Address configurable via keypad) (Net mask configurable via keypad) (Gateway configurable via keypad) (Baud rate configurable via keypad) Remote Control Ethernet (DHCP, TCP/IP, 10/100, up to 12 users) RS-232 (up to 115200 Baud) Remote Commands RF Switch Control Commands: Switch, Set Switch, Read Switch 5-100 MHz 100-1000 MHz System Commands: Help, Identification, Store, Recall, Pause, Net, Serial, Close, Disconnect, MOTD, Date, Message, Restrict, IDENT, Name, Show Users, Reboot, Uptime, Prompt AC Supply 100-240VAC @ 47-63 Hz 2 Amp 5x20mm "Slo-Blo" AC fuse Littelfuse #215-002, JFW #025-021 RF Connector BNC, F or TNC female Operating Temperature Range 0ºC to +50ºC Physical Size See outline drawing 092-8328 ECR/ECN # DATE 06/03/2015 Page 1 of 1 REV APPR / DATE ECR/ECN # BAC 06/03/2015 JFW FORM E-7-F REV F DATE REV APPR / DATE