Plastic Packages for Integrated Circuits Thin Quad Flat No-Lead Plastic Package (TQFN) Thin Micro Lead Frame Plastic Package (TMLFP) L32.5x5A 2X 0.15 C A D A 32 LEAD THIN QUAD FLAT NO-LEAD PLASTIC PACKAGE (COMPLIANT TO JEDEC MO-220WJJD-1 ISSUE C) D/2 MILLIMETERS 2X 6 INDEX AREA N 0.15 C B 1 2 3 SYMBOL MIN NOMINAL MAX NOTES A 0.70 0.75 0.80 - A1 - - 0.05 - 0.30 5, 8 3.55 7, 8 A3 E/2 b E D D2 B TOP VIEW 0.20 REF 0.18 5.00 BSC 3.30 C 0.08 C SEATING PLANE A3 SIDE VIEW A1 3.45 - E 5.00 BSC - 5.75 BSC 9 3.30 e / / 0.10 C - E1 E2 A 0.25 3.45 3.55 0.50 BSC 7, 8 - k 0.20 - - - L 0.30 0.40 0.50 8 N 32 2 Nd 8 3 Ne 8 3 Rev. 2 05/06 NX b 5 0.10 M C A B D2 NX k D2 2 (DATUM B) 8 7 N (DATUM A) 6 INDEX AREA E2 E2/2 3 2 1 NX L N e 8 (Nd-1)Xe REF. BOTTOM VIEW A1 NX b 5 SECTION "C-C" 1 7 (Ne-1)Xe REF. 8 NOTES: 1. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 2. N is the number of terminals. 3. Nd and Ne refer to the number of terminals on each D and E. 4. All dimensions are in millimeters. Angles are in degrees. 5. Dimension b applies to the metallized terminal and is measured between 0.15mm and 0.30mm from the terminal tip. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 identifier may be either a mold or mark feature. 7. Dimensions D2 and E2 are for the exposed pads which provide improved electrical and thermal performance. 8. Nominal dimensions are provided to assist with PCB Land Pattern Design efforts, see Intersil Technical Brief TB389.