AXIAL LEAD TAPING SPECIFICATIONS FOR RECTIFIERS Axial lead devices are packed in accordance with EIA standard RS-296-D and specifications given below. COMPONENT PITCH A +/-0.5mm (.020") INNER TAPE PITCH B +/-1.5mm (.059") CUMULATIVE PITCH TOLERANCE TS-1/A-405 5.0mm 26.0mm 2.0mm/20pitch TS-1/A-405 5.0mm 52.4mm 2.0mm/10pitch DO-41 5.0mm 52.4mm 2.0mm/10pitch DO-15 5.0mm 52.4mm 2.0mm/10pitch DO-201/DO-201AD/P2500 10.0mm 52.4mm 2.0mm/10pitch R-6 10.0mm 52.4mm 2.0mm/10pitch DO-34/DO-35/DO-41 5.08mm±0.4 26.0mm±0.5 2.0mm/20pitch DO-34/DO-35/DO-41 5.08mm±0.4 52.37mm±1.5 2.0mm/10pitch COMPONENT OUTLINE ITEM SYMBOL SPECIFICATIONS (mm) SPECIFICATIONS (inch) Component alignment Z 1.2max 0.048max Tape width T 2.75~6.4 0.11~0.256 Exposed adhesive E 0.8max 0.032max Body eccentricity I L1-L2 I ±1.2 ±0.048 Reel outside diameter D 330~356 13.0~14.24 Reel inner diameter D1 84~87 3.36~3.48 Reel hole diameter Do 16.2~30 0.648~1.2 Reel width (Note2) W 76.0±1.0 2.99±0.040 NOTE: 1.Each component lead shall be sandwiched between tapes for a minimum of 3.2mm(0.126") 2.The reel width "W" for 26mm taping is 50 ±1.0m/m (1.97"±0.03") 168 RADIAL-TAPING SPECIFICATIONS FOR RECTIFIERS (Available For A-405 Packge Only) Radial (Panasert) Ammo Pack A-405 169