RADIAL-TAPING SPECIFICATIONS FOR RECTIFIERS-J TAPING P h A D F d B H W2 L W1 W0 W T P1 P0 D0 t Fig.: Configuration of J-TAPING ITEM Body diameter Body height Lead-wire diameter Component pitch Feed hole pitch Component lead spacing Deflection SPECIFICATIONS(mm) 2.5 0.2 3.1 0.3 0.6 0.1 12.7 1.0 SPECIFICATIONS(inch) 0.098 0.008 0.122 0.012 0.024 0.004 0.500 0.039 PO F 12.7 1.0 5.0 0.8 0.500 0.039 0.197 0.032 0.0 2.0 0.000 0.079 Tape width Hold-down tape width W WO 18.0+1.0/-0.5 12.5 Min. 0.709+0.039/-0.020 0.492 Min. Hold-position Length from seating plane Feed hole diameter Overall tape thickness Cut out length W1 H DO t L 9.0+0.7/-0.50 20.0 0.5 4.0 0.3 0.7 0.2 11.0 Max. 0.354+0.028/-0.020 0.787 0.020 0.157 0.012 0.028 0.008 0.433 Max. Lead protrusion Center of seating plane location Adhesive tape border Lead bend T P1 W2 B 1.0 Max. 6.35 0.7 30 Max. 1.0 Max. 0.039 Max. 0.250 0.028 1.181 Max. 0.039 Max. Notes : E3 SYMBOL D A d P h 1.Devices are packed in accordance with EIA standard RS-468 and specification given above. Available only for R-1 product utilizing 0.6mm diameter leads. 2.Maximum cumulative pitch tolerance:1.0mm/20pitch. 3.Standard packing code is "J". Visit http:// www.rectron.com for complete datasheets