MATERIAL DECLARATION SHEET Material PM2120 Series Product Line SMD POWER INDUCTOR Date 13-September-2006 No. Construction element Material group Material Weight [g] 1 Core Iron Powder 16.65 2 0.15 4 Solder Base Headquarters Riverside CA Average mass [%] Sum [%] Iron 7439-89-6 84.4 100 Resin Trade Secret 9.8 Coating Trade Secret 3.9 Lubricant 110-305/5518-183/67701-02-4 1.9 None 62.5 None 37.5 7440-31-5 96.5 100 7440-50-8 Pending 0.5 3.0 N/A 100 Bar Solder Sn96.5Ag3.0Cu0.5 0.005 Epoxy-Polyester Film; Polymeric Adhesive Sn Base & Terminal of Plastic 1.76 Cu Ag DAP Tape Epoxy-Polyester Film Tape 3 if applicable Materials www.bourns.com CAS N/A Traces 100 page 1 of 2 MATERIAL DECLARATION SHEET 5 6 Wire Enamelled Copper Wire 14.0 Epoxy 0.13 Total weight 32.7 Adhesive Contact person Cathy Godfrey Bourns location Riverside, CA Phone Ext. 5008 Cu 7440-50-8 91.8~99.50 Nylon Polyurethane Coating Epoxy Oxirane Silica,Amorphous N/A 0.5~8.2 25068-38-6 2426-08-6 112945-52-5 N/A 100 Bourns , Inc. 1200 Columbia Ave. Riverside, CA 92507 USA phone: 909 781-5690 fax: 909 781-5273 Fax e-mail 100 [email protected] Important remarks: 1. 2. 3. 4. Traces are product parts substances etc. that are below a percentage of 0.1% of total weight. A list of the legally regulated substances or materials is available at internet address http://www.eicta.org/content.asp?pageID=113 Substances, materials etc. with possible harm to men and environment are listed. There are no risks for human beings and to the environment if products are used properly as designated. This shall not apply to risks caused during procedures for disposal etc. 5. All statements herein are based on our present knowledge. Headquarters Riverside CA www.bourns.com page 2 of 2