MATERIAL DECLARATION SHEET Material CM201212 Series Product Line Wirewound Chip Inductor Date 27-April-2006 1 Construction Element Core 2 Solder Internal Connection 0.0005 3 Pad 0.0015 4 Solder Plate Terminal Electrode Terminal Solder 5 Wire Coated Wire 0.0005 Resin 0.003 Total Weight 0.010 No. 6 Material Group Bobbin Coating Headquarters Riverside CA Material Weight (g) 0.004 0.0005 Polyester Resin Glass Teflon Carbon Black CAS If applicable 60068-52-0 65997-17-3 9002-84-0 1333-86-4 Average Mass (%) 69 30 0.5 0.5 Sum (%) 100 Tin 7440-31-5 14.5 100 Lead 7439-92-1 85.5 Phosphor Bronze - 100 100 Tin 7440-31-5 99.3 100 Copper Copper Polyurethane Resin Epoxy Resin Phenol Novolac Antimony Trichloride Brominated epoxy Fused Silica 7439-92-1 7440-50-8 29690-82-2 9003-35-4 1309-64-4 40039-93-8 60676-86-0 0.7 95 5 18 10 3 2 67 Material www.bourns.com Remark RoHS exempted: High-melting point solder 100 100 page 1 of 2 MATERIAL DECLARATION SHEET Contact person Cathy Godfrey Bourns location Riverside, CA Phone Ext. 5008 Bourns , Inc. 1200 Columbia Ave. Riverside, CA 92507 USA phone: 909 781-5690 fax: 909 781-5273 Fax e-mail [email protected] Important remarks: 1. 2. 3. 4. Traces are product parts substances etc. that are below a percentage of 0.1% of total weight. A list of the legally regulated substances or materials is available at internet address http://www.eicta.org/content.asp?pageID=113 Substances, materials etc. with possible harm to men and environment are listed. There are no risks for human beings and to the environment if products are used properly as designated. This shall not apply to risks caused during procedures for disposal etc. 5. All statements herein are based on our present knowledge. Headquarters Riverside CA www.bourns.com page 2 of 2