Models 7040 BNC (M) Crimp 50 Ω RG174, 188, 188A, 316 Model 7040 BNC (M) 50 Ω Crimp Use for your 50 Ω coax cable assembly applications. Features • Designed for common cables (see table on page 2 for cable types and crimp die information). • Precision machined. • Gold plated (15 micro–inches) contacts. • Insulation material is PTFE (not delrin). Materials • • • Body is machined brass with tarnish resistant nickel plating. Male center pin contacts are gold-plated (15 micro-inches) brass. High quality machined PTFE dielectric. Ordering Information Model: 7040, BNC (M) Crimp 174,188,188A, 316. USA: Sales: 800-490-2361 Technical Support: 800-2412060 Fax: 888-403-3360 Europe: 31-(0) 40 2675 150 International: 425-446-5500 e-mail: [email protected] Where to Buy: www.pomonaelectronics.com See page 2 for cable type, crimp information and cable assembly instructions. Specifications Nominal impedance 50 Ω Frequency 0-4 GHz VSWR 1.30 max. 0-4 GHz Center / Outer contact resistance 1.5 / 1.0 mΩ Number of insertions 500 Insulation resistance 5000 MΩ (min) Dielectric withstand voltage 1500 Vrms Ratings: Voltage: 500 Vrms Operating Temperature: -85 ˚F to +131 ˚F (-65 ˚C to +155 ˚C) Max. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright 2004 9/22004 2398626 D-ENG-N Rev A Page 1 of 2 Models 7040 BNC (M) Crimp 50 Ω RG174, 188, 188A, 316 Cable Type and Crimp Die Set Information Connector Model # 7040 Cable Groups Crimp Die set* Size (Hex/Pin) RG174, 188, 188A, 316 Model 7279 (.178 / .068) *For use with Pomona crimp tool Model 7277. Cable Assembly Instructions USA: Sales: 800-490-2361 Technical Support: 800-2412060 Fax: 888-403-3360 Europe: 31-(0) 40 2675 150 International: 425-446-5500 e-mail: [email protected] Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright 2004 9/22004 2398626 D-ENG-N Rev A Page 2 of 2