Nano Module Mifare® 13.56MHz Contactless Reader/Writer Elatec’s Nano Module Mifare® is designed for integration into machines, handheld computer or any other device. The focus has especially been set on size, price and flexibility. Thanks to its compact dimensions, integration directly on a PC board is possible. Unique features are: 4 user configurable ports (to be configured as input or output), beeper support and different sleep modes for lowest power consumption. The simple ASCII or binary protocol enables quick software development cycles. All host communication is done via serial TTL interface. Elatec GmbH Lilienthalstr. 3 82178 Puchheim Germany Phone: Fax: +49 89 5529961 0 +49 89 5529961 29 [email protected] www.elatec-rfid.com Technical Data Housing Frequency Dimensions (L x W x H) Power Supply Current Consumption Temperature Range Relative Humidity Antenna Read- / Write Distance Supported Transponders Certification Weight Order Code 1) UID Only 2) Support without 13.56 MHz 30.48mm x 25.40mm x 4mm / 1.20inch x 1.00inch x 0.14inch 3.15 – 5.5 V DC Power down: < 300µA RF field off: 2mA RF field on: typically 80mA, depending on antenna Operating: -25°C up to +80°C (-13°F up to +176°F) Storage: -40°C up to +85°C (-40°F up to +185°F) 5% to 95% non-condensing To be connected externally Proximity, depending on antenna and tag ISO14443A Mifare® Classic 1k, 4k, Mini DESfire EV11) Pro X1) SmartMX1) Plus S2), X2) Ultralight, Ultralight C3) SLE44R35, SLE66Rxx Legic® Advant1) RoHS compliant Approx. 3g ART11195 of security level 1 3) without crypto Pinning Schematically picture (component side) Pin 1 2 3, 20 4, 6, 19 5 7, 8, 9, 10 11 12 13 14 Pin spacing 2,54mm 15 16 17 18 Name AntRX AntTX1 VCC GND AntTX2 NC RXD TXD GPIO0 GPIO1/ Beeper Reset Enable GPIO2 GPIO3 Description Antenna receiver input Antenna transmitter output 1 3.3 - 5V Ground Antenna transmitter output 2 Not connected TTL receiver input TTL transmitter output General purpose input/output 0 General purpose input/output 1, connection port for beeper Asynchronous reset Hardware power up/down General purpose input/output 2 General purpose input/output 3 Elatec reserves the right to change any information or data in this document without prior notice. The distribution and the update of this document is not controlled. Elatec declines all responsibility for the use of product with any other specifications but the ones mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility. Where application information is given, it is only advisory and does not form part of the specification © 2011 Elatec GmbH – V2.0 – 01/2011 Elatec GmbH Lilienthalstr. 3 82178 Puchheim Germany Phone: Fax: +49 89 5529961 0 +49 89 5529961 29 [email protected] www.elatec-rfid.com