Nano Module Multi ISO 13.56MHz Contactless Reader/Writer Elatec’s Nano Module Multi ISO is designed for integration into machines, handheld computers or any other device. The focus has especially been set on size, price and flexibility. Thanks to its compact dimensions, integration directly on a PC board is possible. Outstanding features are: 4 user-configurable ports (to be configured as input or output), beeper support and different sleep modes for lowest power consumption. The simple ASCII or binary protocol enables quick software development cycles. All host communication is done via serial TTL interface. The module is prepared for connection of a Secure Access Module (SAM) to achieve maximum flexibility and security features. Elatec GmbH Lilienthalstr. 3 82178 Puchheim Germany Phone: Fax: +49 89 5529961 0 +49 89 5529961 29 [email protected] www.elatec-rfid.com Technical Data Housing Frequency Dimensions (L x W x H) Power Supply Current Consumption Temperature Range Relative Humidity Antenna Read- / Write distance Transponders Supported Certification Weight Order Code 1)UID without 13.56 MHz 30.48mm x 25.40mm x 4mm / 1.20inch x 1.00inch x 0.15inch 5.0 V DC+/-10% Power down: <300uA RF field off: 20mA RF field on: typically 120mA, depending on antenna Operating: -25°C up to +80°C (-13°F up to +176°F) Storage: -40°C up to +85°C (-40°F up to +185°F) 5% to 95% non-condensing To be connected externally Proximity, depending on antenna and tag ISO14443A ISO14443B ® Mifare Calypso Classic 1k, 4k, Mini CEPAS DESfire EV1 Moneo Pro X SRI512, SRT512 SmartMX SRI4K, SRIX4K Plus S, X Ultralight, Ultralight C SLE44R35, SLE66xx my-d move Legic® Advant1) RoHS compliant Approx. 3g ART12607 ISO15693 EM4033 EM4133,EM4233 EM4135 ICODE SLI Inside Picopass1) HID® iClass1) Legic® Advant1) my-d Tag-it Only Pinning Schematically picture (component side) Pin 1 2 3, 20 4, 6, 19 5 7 8 9 10 11 12 Name AntRX AntTX1 VCC GND AntTX2 SAM_Clk SAM_IO SAM_Reset NC RXD TXD Description Antenna receiver input Antenna transmitter output 1 5V Ground Antenna transmitter output 2 SAM module clock SAM module data I/O SAM module reset Not connected RS-232 receiver input RS-232 transmitter output 13 15 16 GPIO0 GPIO1/ Beeper Reset NC General purpose input/output 0 General purpose input/output 1, connection port for beeper Asynchronous reset Not connected 17 18 GPIO2 GPIO3 General purpose input/output 2 General purpose input/output 3 14 Pin spacing 2,54mm Elatec reserves the right to change any information or data in this document without prior notice. The distribution and the update of this document is not controlled. Elatec declines all responsibility for the use of product with any other specifications but the ones mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility. Where application information is given, it is only advisory and does not form part of the specification © 2011 Elatec GmbH – V2.0 – 01/2011 Elatec GmbH Lilienthalstr. 3 82178 Puchheim Germany Phone: Fax: +49 89 5529961 0 +49 89 5529961 29 [email protected] www.elatec-rfid.com