DATA SHEET Part No. MN82860 Package Code No. QFP208-P-2828A SEMICONDUCTOR COMPANY MATSUSHITA ELECTRIC INDUSTRIAL CO., LTD. Publication date: December 2004 SDB00108AEM 1 MN82860 MN82860 Digital RGB Processor LSI Overview This system LSI , MN82860 is a digital RGB processor adapted for high-quality picture of pixel display device. This LSI includes all of picture quality improvement and high speed A/D converter, and realizes high speed processing (100 MHz). So it is suitable for pixel display device dealt with high quality picture and high detailed video. Feature • INPUT Analog/Digital YUV signal Analog/Digital RGB signal • OUTPUT Digital RGB signal • INPUT OUTPUT (Digital each 8 bit) YUV signal • Main Function Clamp control (Clamp current source including) Black/White expansion White character improvement Horizontal aperture correction Contrast adjust Brightness adjust Color control Demodulation axis adjust Demodulation gain adjust RGB matrix OSD data insert (RGB each 2 bit) White balance adjust γ correction (RGB independence) 8 bit high speed A/D converter (3 ch) I2C bus control • Specification Clock frequency 20 MHz to 100 MHz Supply Voltage 3.3 V ± 0.165 V Package 208-pin QFP ( 28 mm, 0.5 mm pitch) Applications Pixel display device such as PDP,LCD SDB00108AEM 2 MN82860 Block diagram , System Configuration , IP Conversion SDB00108AEM 3 Request for your special attention and precautions in using the technical information and semiconductors described in this material (1) An export permit needs to be obtained from the competent authorities of the Japanese Government if any of the products or technical information described in this material and controlled under the "Foreign Exchange and Foreign Trade Law" is to be exported or taken out of Japan. (2) The technical information described in this material is limited to showing representative characteristics and applied circuits examples of the products. It neither warrants non-infringement of intellectual property right or any other rights owned by our company or a third party, nor grants any license. (3) We are not liable for the infringement of rights owned by a third party arising out of the use of the technical information as described in this material. (4) The products described in this material are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: • Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. • Any applications other than the standard applications intended. (5) The products and product specifications described in this material are subject to change without notice for modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (6) When designing your equipment, comply with the guaranteed values, in particular those of maximum rating, the range of operating power supply voltage, and heat radiation characteristics. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, take into the consideration of incidence of break down and failure mode, possible to occur to semiconductor products. Measures on the systems such as redundant design, arresting the spread of fire or preventing glitch are recommended in order to prevent physical injury, fire, social damages, for example, by using the products. (7) When using products for which damp-proof packing is required, observe the conditions (including shelf life and amount of time let standing of unsealed items) agreed upon when specification sheets are individually exchanged. (8) This material may be not reprinted or reproduced whether wholly or partially, without the prior written permission of Matsushita Electric Industrial Co., Ltd. 2003 SEP