Product data sheet

Product datasheet
PTi 20/220…240 S
POWERTRONIC INTELLIGENT PTi S | ECG for HID lamps, for installation in luminaires
Areas of application
_ Shop lighting
_ Health and fitness areas (in dry, corrosion-protected
place)
_ Effect and accent lighting
__
Product benefits
_ Long reliable life at maximum permitted temperatures
_ Compact dimensions and low weight for small luminaire designs
_ Excellent thermal behavior for very high limit temperatures t and t
a
_ Automatic safety shutdown of lamps in the event of a defect cor at end
of life (EoL)
Product features
_ Energy Efficiency Index EEI: A2
_ Supply voltage: 220…240 V
_ Line frequency: 50…60 Hz
_ RI suppression: to EN 55015/CISPR 15
_ Safety: to EN 61347-2-12
_ Line harmonics according to EN 61000-3-2
_ Immunity according to EN 61547
June 7, 2016, 18:17:28
PTi 20/220…240 S
© 2016, OSRAM GmbH. All rights reserved.
Page 1 of 5
Product datasheet
Technical data
Electrical data
__
Lamp wattage
20 W
Line current
0.11 A 1)
Ignition voltage
3.0 kVp
Operating frequency
0.100…0.120 kHz
System wattage
23.00 W
ECG efficiency
87 %
Input voltage AC
198…264 V
Nominal voltage
220…240 V
Mains frequency
50…60 Hz
Power factor λ
0.95
Inrush current
12 A 3)
Max. ECG no. on circuit breaker 10 A (B)
22
4)
Max. ECG no. on circuit breaker 16 A (B)
33
4)
Max. no. of ECGs on 16A MCB with EBN-OS
82
4)
Protective conductor current
0.2 mA
U-OUT (working voltage)
250 V
Max. working voltage between LH and LL
250 V
Max. working voltage betw. LL/LH & earth
250 V
Max. capacitance of wire ECG/lamp
40 pF
2)
1) At 230 V
AC
2) Minimum
3) t
width
4) Type B
= 210 µs (measured at 50 % I
)
peak
Dimensions & weight
Length
97.0 mm
Width
43.0 mm
June 7, 2016, 18:17:28
PTi 20/220…240 S
© 2016, OSRAM GmbH. All rights reserved.
Page 2 of 5
Product datasheet
Height
30.0 mm
Mounting hole spacing, length
88.0 mm
Mounting hole spacing, width
34.0 mm
Cable cross-section, input side
0.5…1.5 mm²
Cable cross-section, output side
0.5…1.5 mm²
Wire preparation length, input side
8.5…9.5 mm
Wire preparation length, output side
8.5…9.5 mm
Product weight
105.00 g
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-25…+60 °C
Maximum temperature at tc test point
80 °C
Lifespan
ECG lifetime
50000 h 1)
1) At maximum T / 10% failure rate
c
__
Additional product data
Design / version
Built-in unit
Capabilities
Max. cable length to lamp/LED module
0.5 m
Overheating protection
Switch off at T > 80 °C at the tc point
ECG reset time
> 0.5 s
Dimmable
No
Restriction on ignition time
20 min
Suitable for fixtures with prot. class
I / II
Certificates & standards
Approval marks – approval
ENEC 10 / VDE / VDE-EMC / EAC / C-Tick
Type of protection
IP20
EEI – Energy Label
A2
Standards
Acc. to EN 61347-2-12/Acc. to EN 55015/Acc. to EN
61000-3-2/Acc. to EN 61547
June 7, 2016, 18:17:28
PTi 20/220…240 S
© 2016, OSRAM GmbH. All rights reserved.
Page 3 of 5
Product datasheet
Wiring Diagram
Wiring diagram
__
Safety advice
Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to
ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value.
Attention!
For safety reasons disconnect the device before replacing the lamp!
Any conductive material must have a minimum distance of 4 mm to the front of the terminal block.
Installation by qualified electrician only.
Terminals for protective earth not suitable for any through connection.
Download Data
File
Tender documents
Tender Document for POWERTRONIC EVG.eng
Certificates
EMC-Marks approval
Certificates
PTi - PTo - PTg VDE-ENEC-Cert
June 7, 2016, 18:17:28
PTi 20/220…240 S
© 2016, OSRAM GmbH. All rights reserved.
Page 4 of 5
Product datasheet
Certificates
EAC PT family
Declarations of conformity
Declaration of conformity PTi 20
Declarations of conformity
VDE Declaration of conformity
Installation/Operation notice
Technical guide - POWERTRONIC for HID-lamps (GB)
Operating instructions
EAC - PTI S PT-FIT S
CAD data 3-dim
PTm 20 S 9900046
CAD data 3-dim
PTm 20 S 9900046
CAD data 3-dim
PTm 20 S 9900046
CAD data PDF
PTm 20 S 9900046
Logistical Data
__
Product code
Product description
Packaging unit (Pieces/Unit)
Dimensions (length x width x
height)
Volume
Gross weight
4008321353290
PTi 20/220…240 S
Shipping carton box
20
228 mm x 78 mm x 208 mm
3.70 dm³
2106.00 g
The mentioned product code describes the smallest quantity unit which can be ordered. One shipping unit can contain one or
more single products. When placing an order, for the quantity please enter single or multiples of a shipping unit.
Disclaimer
Subject to change without notice. Errors and omission excepted. Always make sure to use the most recent release.
June 7, 2016, 18:17:28
PTi 20/220…240 S
© 2016, OSRAM GmbH. All rights reserved.
Page 5 of 5