CERTIFICATE America No. B 10 10 34962 104 Holder of Certificate: SynQor Inc. 155 Swanson Road Boxborough, MA 01719-1316 USA Production Facility(ies): 34962 Certification Mark: Product: IT Equipment Power Interface Module Model(s): 1Q65033QMA10 (see certificate attachment for license conditions) Parameters: 36-75 V DC Rated Input Voltage: 10 A Rated Input Current: 300 Watts max. Rated Output Current: IPXO Degree of Protection: (See attachment for additional rating information.) Tested according to: EN 60950-1/A1:2010 The product was tested on a voluntary basis and complies with the essential requirements. The certification mark shown above can be affixed on the product. It is not permitted to alter the certification mark in any way. In addition the certification holder must not transfer the certificate to third parties. See also notes overleaf. Test report no.: Date, 090-700863-000 2010-10-21 Page 1 of 2 422877 TUV SOD AMERICA INC • 10 Centennial Drive • Peabody, MA 01960 USA • www.TUVamerica.com Attachment to Certificate No.: B 10 10 34962 104 Company: SynQor Inc. 155 Swanson Road Boxborough, MA 01719-1316 USA America Rating Information: 36-75 Vdc, 7.5 A, 400 LFM 48 Vdc, 10 A, 950 LFM Outputs: IMP 3.3 Vdc 3.6 A, 5.0 Vdc, 150 mA License Conditions: When installed in the end product, consideration shall be given to the following: 1. The units should be installed per the manufacturer's specification. 2. Maximum output power is specified at 25°C and 950 LFM at normal voltage of 48 VDC, 3. Maximum output power is specified at 25°C and 400 LFM at normal voltage of 36-75 VDC. 4. Abnormal and Component Failure Tests were conducted with the power supply input protected by a 3 AG 15 A, 250 V fuse. If a fuse rated greater than 3AG 15 A is used, additional testing may be required. 5. If the input meets all of the requirements for SELV (V < 60), the outputs may be considered SELV. Output voltages remain within SELV limits. 11111:3 R=.-3 6. These units are intended to be supplied from an isolated source of supply, such as a battery, or a source which meets the requirements for basic (ELV) or reinforced (SELV) insulation from primary (mains) circuitry, depending on output type desired. Test Report No.: 090-700863-000 Date: 2010-10-21 Page 2 of 2 TON/ SOD AMERICA INC • 10 Centennial Drive • Peabody, MA 01960 USA • www.TUVamerica.com TEA/c)