Part No: 20110 - A1/2 Series Tip Over Switch - Mercury Features: * Un-Insulated * Form: NO/SPST/Vertical Mount as shown * Angles Referenced from Vertical * Side Pin 2nd Electrode * Omni-Directional * Hermetically Sealed * Small Package Size * Long Life Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Must Make / Break Angle : Maximum included Angle: Switch Ratings: Max Switching Voltage Max Switching Current Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / millimeters: Maximum Diameter. Inches / millimeters: Materials: Lead Wire Type Lead wire length/skive/termination Finish: © American Electronic Components Inc 2006 Specifications are subject to change without notice. E&OE. Drawing dimensions in inches and (millimeters). Must make between 45º and 75º from vertical Load dependent 12V DC 10mA 10 Ohms 1kV AC -38º to 220ºF / -38º to 105ºC -40º to 356ºF / -40º to 180º C 10,000,000 N/A 0.33 / .015 0.39 / 9.91 0.31 / 7.9 N/A N/A Tin American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com 20110 220806