Part No: 3018 - A1 Series Tilt Switch - Mercury Features: * Un-Insulated * Form: NO/NC/SPST/Mount dependent * Anti-Vibration Tilt Switch * Angles are application dependent * Single Electrode * Hermetically Sealed * Small Package Size * High Current Capability * Low Contact Resistance * Long Life Drawing dimensions in inches. Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Must Make / Break Angle * : Maximum included Angle: Application dependent * Make/break angles are electrode + (above) / - (below) 0° horizontal reference Switch Ratings: Max Switching Voltage Max Switching Current Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / Millimeters: Maximum Diameter. Inches / Millimeters: Materials: Lead Wire Type Lead wire length/skive/termination Finish: © American Electronic Components Inc 2006 Specifications are subject to change without notice. E&OE. 240V 120VAC / 1A, 240VAC / 0.7A : 120VDC / 0.5A, 240VDC / 0.4A : Tungsten 240V / 100W 600 milli Ohms 1 kV AC -38º to 220ºF / -38º to 105ºC -40º to 356ºF / -40º to 180º C 10,000,000 N/A 1.10 / 0.50 0.71 / 18.06 0.39 / 9.91 N/A N/A American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com 3018 090606