STEVAL-IHT001V2 Cold thermostat kit based on AC switches and the STM8S Data brief Features ■ Low-cost solution for spark-free thermostats: – No need for a sealed version – Low-cost STM8S microcontroller for thermostat control – Low-cost capacitive power supply ■ High efficiency: – Refrigerator consumption reduction by adjusting and reducing the hysteresis threshold of the temperature – Improved efficiency by turning on the defrost resistor only when it's useful and not at each OFF cycle of the compressor (as done in some mechanical thermostats) ■ High system immunity: – Overvoltage protected ACS switches: ACST610-8FP for compressor control, ACS110-7SN for defrost resistor and ACS102-6TA for light bulb and fan – Class A criteria for IEC 61000-4-4 up to above 3 kV levels ■ ■ Flexibility: – Development: program setting with PC interface to change firmware variables – Industrialization: end-of-production MCU programming thanks to FLASH, for soft upgrade and efficient MCU stock management RoHS compliant Description a light bulb, and optionally, a defrost resistor and a fan, working on 220/240 VRMS, 50/60 Hz mains voltage. The thermostat kit is operational with 100/120 V RMS 50/60 Hz but the supply capacitor value must be modified. The board can operate in an ambient temperature range from 0 °C to 60 °C. The exact maximum temperature depends on the power of the loads. For demonstrative purposes a graphic user interface (GUI) has been developed. The connection between the PC and STM8S microcontroller, the MCU performing thermostat regulation, is achieved through a USB bus. As the STM8S is a low-cost MCU without an embedded USB peripheral, an additional MCU (STM32) has been used as a bridge between the PC and STM8S MCU, for demonstrative purposes only. The STEVAL-IHT001V2 thermostat kit provides a robust and low-cost ST solution (microcontroller and AC switches) to control refrigerators, freezers or fridge/freezer combinations. Basic, defrost, and air circulation versions are configurable in order to address the low-end and medium-end cooling appliances market. It allows the control of a single-phase induction motor and October 2012 Doc ID 023175 Rev 3 For further information contact your local STMicroelectronics sales office. 1/7 www.st.com 7 2/7 1 ' Doc ID 023175 Rev 3 *5((1B/(' ' *5((1B/(' ' *5((1B/(' ' *5((1B/(' ' 5 5 5 5 2+0 2+0 2+0 5 2+0 5 5 '2256:,7&+ /(' /(' /(' /(' /(' '2256:,7&+ 5 73 =96 & Q) & Q) 6: '2256:,7&+ 5 . *1'B670 9&&B670 & Q) =96B3,1 9&&B0$,16 2+0: 2+0:PHWDOOLF .2+0:PHWDOOLF 2+0:PHWDOOLF 2+0 5 9$5,6725 59 Q); & 5 - %8==(5 3= & Q) 5 2+0: & Q) )$1B3,1 & Q) & Q) 73 /,*+7 5 . 17& /,*+7B3,1 6: 7386+%87721 7(03386+%87721 *1'B670 & Q) - 5 2+0 $&67$ 9&&B670 4 5 2+0:PHWDOOLF 7(03386+%87721 5 . *1'B670 - /,*+7 5 2+0: 9&&B670 17& 5 2+0 $&67$ 4 73 )$1 7(03386+%87721 7386+%87721 6: & Q) 5 2+0: - )$1 '()5267B3,1 2+0 5 $&6 4 73 '()5267 7(03386+%87721 5 . *1'B670 9&&B670 %8==(5 &2035(6625B3,1 2+0 5 *1'B670 !#34 '2256:,&+7 4 - '()5267 Control side schematic *5((1B/(' ' X); & - 73 &2035(6625 581 Figure 1. )86(+2/'(5 ) ' 9: 73 1 Schematic diagrams 5('B/(' ' & X) 9&&B0$,16 - &21 1 *1'B670 *1' 73 9'' 73 73 / Schematic diagrams STEVAL-IHT001V2 !-V Doc ID 023175 Rev 3 Q) & . *1'B670 5(6(7 6: 670B5(6(7 /(' /(' Q) & *1'B670 $'',7,21$/386+%87721 2+0 3& 3' 2+0 5 3$+6 9&$3 3$ 3$ 1567 6:'3'7 6: 9&&B670 3'8$57B5; 3'8$57B7; 3' 9'' 5 5 670B5(6(7 86$57B7;B670 86$57B&76B670 /(' 9&&B670 '2256:,7&+ 5 5 1 ' 3& 670B6:,0 *1'B670 6706) 3%7 3%7 3&+6 3&+6 3&+6 3&+6 3&+6 3'+66:,0 /(' Q) & & X) 3'+6$,1 3'+6$,1 966 9&&B670 7(03386+%87721 $'',7,21$//(' 86$57B5;B670 3' 8 5 5 2+0 5 17& 2+0 5 & Q) & Q) /,*+7B3,1 6:,0BOLQH /(' *1'B670 & Q) =96B3,1 &2035(6625B3,1 6:63'7 - 7(03386+%87721 327(17,20(7(5 & Q) '()5267B3,1 )$1B3,1 Figure 2. %8==(5 $GGLWLRQDO/(' STEVAL-IHT001V2 Schematic diagrams Control side schematic - STM8S !-V 3/7 4/7 Q & Doc ID 023175 Rev 3 X) & X) & X) & '&'&B9 86%B9 *1' 92 QF 9'' *1' 92 QF 9'' *1' QF 9, 9'' $&3// *1' QF 9, 9'' 8 $&3// *1' QF 9, 9'' 8 $&3// *1' 92 QF 9'' 8 '&'&B9 /' QF 9287 9287 QF /(' ' 86$57B&76B670 86$57B5;B670 86$57B7;B670 5 2+0 9&&B9 9,1 9287 9287 *1' 8 2+0 2+0 2+0 5 5 5 X) & 9&&B9 X) & 9&&B9 X) & 9&&B9 86%B0,1,% &1 6/,4!'%2%'5,!4/ 2 5 0 6: ,0BOLQH 86%B9 0+] < S) & 9&&B9 6: ',2 6: &/. - *1'B670 - &21 670B5(6(7 9&&B670 9&&B0$,16 &21 5 . 6: ,0BFRQQHFWRU - & Q) . '&'&B9 Q) & 5 2+0 *1'B670 5 S) & 5(6(7 86%B'3 86%B'0 86$57B7;B670 86$57B5;B670 86$57B&76B670 &21 - 670)& 966$ 9''$ %227 1567 3'26&B,1 3'26&B287 3$86$57B&76 3$86$57B576 3$86$57B7; 3$86$57B5; 3$63,166 3$63,6&. 3$63,0,62 3$63,026, 3$86$57&. 3$86$577; 3$86$575; 3$86$57&7686%'0 3$86$5757686%'3 3$-7066:',2 3$-7&.6:&/. 3$-7', 8 & & Q) & Q) 6: 'BFRQQHFWRU - 670B5(6(7 5 . 9&&B9 Q) & 9&&B9 Q) & 86%B',6&211(&7 Q) & Q) X) 3702/'$"5'#/..%#4/2 & 9&&B9 3&7$03(557& 3&26&,1 3&26&287 3%$'&,1 3%$'&,1 3%%227 3%-7'2 3%-1567 3%,&B60%$ 3%,&B6&/ 3%,&B6'$ 3% 3% 3% 3% 3% 3% 3% 3% 670B5(6(7 6: ',2 6: &/. 966 966 966 86$57B&76B670 86$57B7;B670 ' /04/#/50,%23 '&'&B9 9RXW 9RXW 7(61 1& 9LQ - '&'&B9 9LQ 0 5 ' 9 ' 86%8): $#$##/.6%24%2 *1' ' 8 86%B9 9&&B9 9'' 9'' 9'' 86$57B5;B670 86%B'0 9&&B9 9&&B9 9%$7 86%B'3 5 . 86%B9 53"#/..%#4/2 Figure 3. 86%B',6&211(&7 Schematic diagrams STEVAL-IHT001V2 Interface side schematic !-V STEVAL-IHT001V2 Figure 4. Schematic diagrams Additional pads schematic 9&&B670 9&&B670 5 5 '1) '1) 327(17,20(7(5 $'',7,21$/386+%87721 6: & '1) '1) '1) & *1'B670 ' *1'B670 5 $GGLWLRQDO/(' '1) '1) *1'B670 ' 5 $GGLWLRQDO/(' '1) '1) *1'B670 !-V Doc ID 023175 Rev 3 5/7 Revision history 2 STEVAL-IHT001V2 Revision history Table 1. 6/7 Document revision history Date Revision Changes 31-May-2012 1 Initial release. 18-Sep-2012 2 Changed: figure in cover page and Figure 1 16-Oct-2012 3 Updated features. Doc ID 023175 Rev 3 STEVAL-IHT001V2 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2012 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com Doc ID 023175 Rev 3 7/7