GP15A THRU GP15M SINTERED GLASS JUNCTION PLASTIC RECTIFIER VOLTAGE:50 TO 1000V CURRENT: 1.5A FEATURE DO-15\DO-204AC High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C/10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal run away Typical Ir<0.1µA MECHANICAL DATA Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Case: Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: color band denotes cathode Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8”lead length at Ta =55°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at 1.5A Maximum full load reverse current full cycle Average at 55°C SYMBOL GP 15A GP 15B GP 15D GP 15G GP 15J GP 15K GP 15M units Vrrm Vrms Vdc 50 35 50 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V If(av) 1.5 A Ifsm 50.0 A Vf 1.1 V Ir(av) 100.0 µA µA µA µS Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =150°C Typical Reverse Recovery Time (Note 1) Ir 5.0 200.0 Trr 2.0 Typical Junction Capacitance Cj 15 pF R(ja) 45.0 Tstg, Tj -65 to +175 °C /W °C Typical Thermal Resistance (Note 2) (Note 3) Storage and Operating Junction Temperature Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A4 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GP15A THRU GP15M 1 1 Rev.A4 www.gulfsemi.com