Product Brief MICROWAVE & HIGH RELIABILITY PRODUCTS SMI7335 2x2 Multi-band MIMO Dual-channel RF transceiver for TDD and HFDD applications Product Description SMI7335 is a dual-channel RF transceiver for TDD and HFDD applications. The transceiver supports a full 2 x 2 MIMO configuration with two independent transmit and receive chains. The transceiver uses direct-conversion architecture. The received RF signal is downconverted to baseband. Internal switches allow adjustment of the amplitude and phase of the baseband signal to achieve optimal channel balance. The LO is generated by an internal fractional-N synthesizer capable of <100 Hz steps. The internal registers are loaded via a standard SPI interface. 4 Supports BW’s of 3.5, 5, 7, 8.75, 10, 14 and 20 MHz 4On-chip peak and log detectors Applications 4 HFDD radios 4 TDD radios Evaluation Board Product Highlights 4 Quad Band • 1.1 - 1.5 GHz • 1.6 - 2.0 GHz • 2.3 - 3.0 GHz • 3.2 - 4.0 GHz 4 Full 2x2 MIMO operation 4 Supports Wave 2 WiMAX Forum certification 4 EVM<-32db (typical) 4 DC power, 2.8V and 1.8V Supplies, 280mW in TX mode, 290 mW in RX mode (2x1 config) 4 Direct conversion architecture for lowest cost Package 8mm x 8mm 64 lead QFN W W W .SE MTE CH .COM SIERRA MONOLITHICS Product Brief SMI7335 Block Diagram — 2x2 Multi-band MIMO RFIC Sierra Monolithics Inc. is now part of Semtech Incorporated. ©2010 Semtech Corporation. All Rights Reserved. Specification subject to change without notice. W W W .SE MTE CH .COM SIERRA MONOLITHICS SMI7335-PB