HSMC INTERCONNECT BOARD CYUSB3ACC-006 1. Connect the EZ-USB® FX3™ SuperSpeed Explorer Kit (CYUSB3KIT-003) to the HSMC Interconnect Board (CYUSB3ACC-006) 2. Plug the HSMC Interconnect Board (CYUSB3ACC-006) into the Altera® FPGA board (The Altera FPGA board is not part of this kit) 3. Make sure that Jumper J5 on CYUSB3KIT-003 is open 4. Learn to use FX3 in applications involving Altera FPGA with the application note AN65974 - Designing with the EZ-USB® FX3TM Slave FIFO Interface available at http://www.cypress.com/go/AN65974 HSMC INTERCONNECT BOARD CYUSB3ACC-006 Note: Please take care when removing the accessory board from the SuperSpeed Explorer Kit board. The suggested removal method is shown in the picture above. Hold the accessory board and use a rocking motion to separate the boards safely For the latest information about this interconnect board and to download the hardware files, visit www.cypress.com/go/CYUSB3ACC-006 For the latest information about EZ-USB FX3 SuperSpeed Explorer Kit (CYUSB3KIT-003) and to download Kit Software and Hardware files, visit www.cypress.com/go/SuperSpeedExplorerKit © 2014 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.# 001-92306 Rev**