RHD5920 (9/13)

Standard Products
RadHard-by-Design
RHD5920 Analog Multiplexer
16-Channel
www.aeroflex.com/RHDseries
September 9, 2013
FEATURES









Single power supply operation at 3.3V to 5V
Radiation performance
- Total dose:
>1Mrad(Si); Dose rate = 50 - 300 rads(Si)/s
- ELDRS Immune
- SEL Immune
>100 MeV-cm2/mg
- Neutron Displacement Damage >1014 neutrons/cm2
Full military temperature range
Rail to Rail operation
Low power consumption < 4.0mW
One address bus (A0-3), and one enable line
Designed for aerospace and high reliability space applications
Packaging – Hermetic ceramic
- 24-pin, 0.614"L x 0.300"W x 0.105"Ht SOIC
- Typical Weight 2 grams
Aeroflex Plainview’s Radiation Hardness Assurance Plan is DLA Certified to MIL-PRF-38534, Appendix G.
GENERAL DESCRIPTION
Aeroflex’s RHD5920 is a radiation hardened, single supply, 16 Channel Multiplexer in a 24-pin SOIC
package. The RHD5920 design uses specific circuit topology and layout methods to mitigate total ionizing
dose effects and single event latchup. These characteristics make the RHD5920 especially suited for the
harsh environment encountered in Deep Space missions. It is guaranteed operational from -55°C to
+125°C. Available screened in accordance with MIL-PRF-38534 Class K, the RHD5920 is ideal for
demanding military and space applications.
ORGANIZATION AND APPLICATION
The RHD5920 is a 16 to 1 CMOS multiplexer. Channel selection is controlled by 4 bit binary addressing
and an active low enable. All inputs and outputs are diode protected.
The devices will not latch with SEU events to above 100 MeV-cm2/mg. Total dose degradation is minimal
to above 1Mrad(Si). Displacement damage environments to neutron fluence equivalents in the mid 1014
neutrons per cm2 range are readily tolerated. There is no sensitivity to low-dose rate (ELDRS) effects. SEU
effects are application dependent.
SCD5920 Rev D
VOUT
1
24
VCC
CH15
2
23
CH7
CH14
3
22
CH6
CH13
4
21
CH5
CH12
5
20
CH4
6
19
CH3
18
CH2
CH11
5920
CH10
7
CH9
8
17
CH1
CH8
9
16
CH0
A3
10
15
EN
A2
11
14
A0
GND
12
13
A1
CH15
16
•
•
•
CH0
MUX
VOUT
EN
A3
A2
A1
A0
Notes:
1. Package and lid are electrically isolated from signal pads.
RHD5920: 16 CHANNEL ANALOG MUX
SCD5920 Rev D 9/9/13
2
Aeroflex Plainview
ABSOLUTE MAXIMUM RATINGS
Parameter
Range
Units
Case Operating Temperature Range
-55 to +125
°C
Storage Temperature Range
-65 to +150
°C
+6.0
V
Digital Input Overvoltage
(VEN, VA)
< VCC +0.4
> GND -0.4
V
V
Analog Input Over Voltage
(CH0-CH15)
< VCC +0.4
> GND -0.4
V
2,000 - 3,999
V
Supply Voltage
(+VCC)
ESD Rating (MIL-STD-883, Method 3015, Class 2)
NOTICE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress rating
only; functional operation beyond the "Operation Conditions" is not recommended and extended exposure beyond the "Operation Conditions" may
affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Symbol
Typical
Units
Power Supply Voltage
3.3 to 5.0
V
VIL
Low Level Input Voltage
30% VCC
V
VIH
High Level Input Voltage
70% VCC
V
+VCC
Parameter
ELECTRICAL PERFORMANCE CHARACTERISTICS
(TC = -55°C TO +125°C, +VCC = +5V -- UNLESS OTHERWISE SPECIFIED)
Parameter
Supply Current
(+VCC) 1/
Symbol
Conditions
Units
EN = 30% VCC
-
800
A
+ISBY
EN = 70% VCC
-
200
A
IAL
VA = 30% VCC
+25°C
-5
5
nA
+125°C
-50
50
nA
IAH
VA = 70% VCC
+25°C
-5
5
nA
+125°C
-50
50
nA
IENL
VEN = 30% VCC
+25°C
-5
5
nA
+125°C
-50
50
nA
IENH
VEN = 70%VCC
+25°C
-5
5
nA
+125°C
-50
50
nA
+25°C
-5
5
nA
+125°C
-50
50
nA
+25°C
-5
5
nA
+125°C
-50
50
nA
+25°C
-5
5
nA
+125°C
-50
50
nA
VIN = 0V, VEN = 30% VCC, IOUT = +1mA
-55°C
-
500

VIN = +2.5V, VEN = 30% VCC, IOUT = -0.6mA
+25°C
-
750

VIN = +5V, VEN = 30% VCC, IOUT = -1mA
+125°C
-
1000

Enable Input Current
(EN) 1/
High Input
Leakage Current
(CH0-CH15) 1/
IINLK5
VIN = +5V, VEN =70% VCC,
Output and all unused MUX inputs under test =
0V
Low Input
Leakage Current
(CH0-CH15) 1/
IINLK0
VIN = 0V, VEN =70% VCC
Output and all unused MUX inputs under test =
+5V
Output Leakage Current
(VOUT) 1/
IOUTLK
VOUT = +5V, VEN = 70% VCC ,
All inputs grounded except channel being tested
1/
Max
+ICC
Address Input Current
(A0-A3) 1/
Switch ON Resistance
Min
RDSON
1/ Specification derated to reflect Total Dose exposure to 1 Mrad(Si) @ +25°C
SCD5920 Rev D 9/9/13
3
Aeroflex Plainview
SWITCHING CHARACTERISTICS
(TC = -55°C TO +125°C, +VCC = +5V -- UNLESS OTHERWISE SPECIFIED)
Symbol
Parameter
Conditions
tAHL
VOUT High to Low Transition
Address to Output Delay
tALH
VOUT Low to High Transition
tONEN
Enable to Output Delay
(Enabled)
tOFFEN
(Disabled)
Temp
Min
Max
Units
-55°C
10
150
ns
+25°C
10
150
ns
+125°C
10
200
ns
-55°C
10
150
ns
+25°C
10
150
ns
+125°C
10
200
ns
-55°C
10
150
ns
+25°C
10
150
ns
+125°C
10
200
ns
ALL
10
200
ns
TRUTH TABLE (CH0 – CH15)
A3
A2
A1
A0
EN
"ON" CHANNEL 1/
X
X
X
X
H
NONE
L
L
L
L
L
CH0
L
L
L
H
L
CH1
L
L
H
L
L
CH2
L
L
H
H
L
CH3
L
H
L
L
L
CH4
L
H
L
H
L
CH5
L
H
H
L
L
CH6
L
H
H
H
L
CH7
H
L
L
L
L
CH8
H
L
L
H
L
CH9
H
L
H
L
L
CH10
H
L
H
H
L
CH11
H
H
L
L
L
CH12
H
H
L
H
L
CH13
H
H
H
L
L
CH14
H
H
H
H
L
CH15
1/ Between (CH0-CH15) and VOUT
SCD5920 Rev D 9/9/13
4
Aeroflex Plainview
VIH
Address Lines
(A0 - A3)
50%
VIL
VIN(CH A0-3’)
Output
VOUT
50%
VIN(CH A0-3)
t AHL
VIH
Address Lines
(A0 - A3)
50%
VIL
VIN(CH A0-3’)
Output
VOUT
50%
VIN(CH A0-3)
t ALH
VIH
Enable Line
EN
50%
VIL
VIN(HIGH)
Output
VOUT
SELECTED
CHANNEL
HI-Z
HI-Z
50%
VIN(LOW)
tONEN
tOFFEN
NOTE: f = 10KHz, Duty cycle = 50%.
RHD5920 SWITCHING DIAGRAMS
SCD5920 Rev D 9/9/13
5
Aeroflex Plainview
ORDERING INFORMATION
Model
DLA SMD #
Screening
RHD5920-7
-
Commercial Flow, +25°C testing only
RHD5920-S
-
Military Temperature, -55°C to +125°C
Screened in accordance with the individual Test Methods
of MIL-STD-883 for Space Applications
RHD5920-201-1S
5962-1024301KXC
RHD5920-201-2S
5962-1024301KXA
RHD5920-901-1S
5962H1024301KXC
RHD5920-901-2S
5962H1024301KXA
In accordance with DLA SMD
Package
24-pin SOIC
In accordance with DLA Certified RHA Program Plan to
RHA Level "H", 1Mrad(Si)
Note: Package and lid are electrically
isolated from signal pads.
PACKAGE OUTLINE
EXPORT CONTROL:
EXPORT WARNING:
This product is controlled for export under the International Traffic in
Arms Regulations (ITAR). A license from the U.S. Department of
State is required prior to the export of this product from the United
States.
Aeroflex’s military and space products are controlled for export under
the International Traffic in Arms Regulations (ITAR) and may not be
sold or proposed or offered for sale to certain countries. (See ITAR
126.1 for complete information.)
PLAINVIEW, NEW YORK
Toll Free: 800-THE-1553
Fax: 516-694-6715
INTERNATIONAL
Tel: 805-778-9229
Fax: 805-778-1980
NORTHEAST
Tel: 603-888-3975
Fax: 603-888-4585
SE AND MID-ATLANTIC
Tel: 321-951-4164
Fax: 321-951-4254
WEST COAST
Tel: 949-362-2260
Fax: 949-362-2266
CENTRAL
Tel: 719-594-8017
Fax: 719-594-8468
www.aeroflex.com
[email protected]
Aeroflex Microelectronic Solutions reserves the right to
change at any time without notice the specifications, design,
function, or form of its products described herein. All
parameters must be validated for each customer's application
by engineering. No liability is assumed as a result of use of
this product. No patent licenses are implied.
SCD5920 Rev D 9/9/13
Our passion for performance is defined by three
attributes represented by these three icons:
solution-minded, performance-driven and customer-focused
6