INFINEON SDA9380

Product Brief
EDDC
SDA 9380
Potential Application
The SDA 9380 is a new component
of the Infineon MEGAVISION® IC
set to support single chip back end solutions for SDTV up to HDTV CRT’s
Features Deflection Controller
■ H- and V-blanking time
■ PLL on chip - no external clock
■
■
■
■
■
■
■
■
required
I2C-Bus alignment for all deflection parameters
Line frequencies / standards
PAL 50 Hz p, 100 Hz i - 31.2 kHz
NTSC 60 Hz p, 120 Hz i - 31.5 kHz
HDTV ATSC
- 32.4 kHz
HDTV MUSE
- 33.7 kHz
SVGA
- 38 kHz
Automatic switching between
31, 35 and 38 kHz in monitor
mode
Picture width and picture height
EHT compensation
Upper/lower EW corner correction separately adjustable
V-angle and V-bow correction
Vertical zoom/shrink and scroll
function
No re-adjustment of E/W after
changing vertical S-correction
and linearity
■
■
■
■
■
■
■
■
adjustable
Auto adaption of V-frequency
in the range of 192 and 680 lines
per field
Selectable black switch off
modes
Selectable softstart of the H-output stage
Protection against EHT run
away (X-rays protection)
Protection against missing
V-deflection (CRT-protection)
H-frequent PWM output signal
for generating an adjustable vertical frequent parabola or a constant pulse width
DAC output with 8-Bit resolution
for general purpose
Digital output for general
purpose
EDDC
Features YUV/RGB
■ Two YUV/RGB inputs and one
■
■
■
■
■
■
■
■
RGB input with fast blanking
capability
Switchable color difference
matrix for PAL/SECAM, NTSC
(U.S. and Japan) and HDTV
Common saturation, brightness
and contrast control for all input
channels
Cut off and white level control
loop
Black stretching of non-standard
input signal
Selectable blue stretch function
Peak drive limiter with
soft clipping
Average beam current limiter
Luminance output signal SVM
for scan velocity modulation,
adjustable delay from SVM to
the RGB outputs
http://www.infineon.com
SDA 9380
Block Diagram
YUV/
RGB1/FBL1 RGB2/FBL2
Y/R
U/G
V/B
MATRIX
PAL/SECAM
NTSC US/Japan
HDTV
HSYNC
VSYNC
SVM
Cut-off
Analog Signal
Processing
RGB Switch
R
G
B
HD
EW
VO
Digital Deflection Controller
Ι2C
VPROT HPROT
IBEAM
FB
Technical Data
■ I2C-Bus control
■ P-MQFP-64 package
■ 3.3 V and 8 V supply voltages
How to reach us:
http://www.infineon.com
Application Example
Published by
Infineon Technologies AG,
Bereich Kommunikation,
St.-Martin-Strasse 53,
D-81541 München
© Infineon Technologies AG 1999
All Rights Reserved.
Attention please!
The information herein is given to describe certain components and shall not be considered as
warranted characteristics.
SVGA
CVBS
(4 in, 2 out),
Y/C
2x
RGB, FBL
Terms of delivery and rights to technical change
reserved.
Single Chip - Scan Rate Converter
YUV*
- Color Decoder
- RGB Input
- SRC Field Based
Backend
EDDC
HV
RGB*
HV, EW
SDA 9380
SDA 9402
RGB
Ι2C Bus, Clock
SDA 6000
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and
charts stated herein.
Infineon Technologies is an approved CECC
manufacturer.
Information
For further information on technology, delivery
terms and conditions and prices please contact
your nearest Infineon Technologies Office in
Germany or our Infineon Technologies Representatives worldwide (see address list).
Warnings
Due to technical requirements components may
contain dangerous substances. For information
on the types in question please contact your
nearest Infineon Technologies Office.
Infineon Technologies Components may only be
used in life-support devices or systems with the
express written approval of Infineon Technologies,
if a failure of such components can reasonably
be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support
devices or systems are intended to be implanted
in the human body, or to support and/or maintain
and sustain and/or protect human life. If they fail,
it is reasonable to assume that the health of the
user or other persons may be endangered.
Published by Infineon Technologies AG
Ordering No. B111-H7504-X-X-7600
Printed in Germany
PS 08993.