STEVAL-IDB005V1D RF daughterboard platform based on BlueNRG-MS Data brief Description The STEVAL-IDB005V1D is an RF daughterboard platform based on the BlueNRGMS low power Bluetooth® Smart IC, compliant with the Bluetooth® 4.1 specifications and supporting both master and slave roles. The STEVAL-IDB005V1D RF daughterboard features the BlueNRG-MS device, an SMA connector for antennas or measuring instruments and an SPI connector for an external microcontroller. It can be connected to STM32L motherboards available with the STEVALIDB002V1 and STEVAL-IDB005V1 platforms. Features Bluetooth® SMART RF daughterboard based on the BlueNRG-MS low energy network processor Maximum transmission power +8 dBm Excellent receiver sensitivity (-88 dBm) Very low power consumption: 7.3 mA RX and 8.3 mA TX at +0 dBm Bluetooth® low energy 4.1 compliant, supports both master and slave roles RoHS compliant December 2015 DocID028757 Rev 1 For further information contact your local STMicroelectronics sales office 1/4 www.st.com 3V3 2/4 1 2 3 4 10 8 6 4 2 9 7 5 3 1 GSPG1412150835SG DocID028757 Rev 1 MISO MOSI CLK CSN C19 100n_0402_ X7R RST 100k_040 2 R7 R9 100k_040 2 J4 HEADER 5X2 1u_0402_ X5R C20 VDD VBAT 2 VBAT 1 100n_0402_ X7R C21 100n_0402_ X7R C18 100p_0402_CO G TEST12 TEST11 TEST9 TEST8 1u_0402_ X5R C17 TEST7 TEST6 TEST5 1u_0402_ X5R C22 VDD TEST12 U4 B1 B2 A1 A2 AUXADN AUXADP SOSC OUT TBD_040 2 L1 15p_0402_CO G C14 100n_0402_ X7R C23 1 2 VDD BALF -NRG-01D3 TEST11 TEST8 XTAL_H S VBAT 3 C16 100n_0402_ X7R C13 Q2 VBAT 2 Q1 C6 TBD_040 2 XTAL_L S L2 4 3 nc R1 1 TEST10 JP1 TEST10 VDD 3 J2 SMA connector 10k_040 2 R2 2 M9564 0 CLK MOSI 9 7 5 3 1 16 15 14 13 12 11 10 9 C15 24 23 22 21 20 19 18 17 15p_0402_CO G VBAT 1 SXTAL0 SXTAL1 RF0 RF1 VBAT 2 FXTAL0 FXTAL1 22p_0402_CO G C5 VDD 2 NO_SMPS nS Vcc Q nHOLD nW C Vss D 8 7 6 5 10 8 6 4 2 U3 IRQ TEST12 TEST11 TEST9 TEST8 VDD1V 8 TEST7 TEST6 TEST5 nS MISO TEST9 TEST1 VDD GND SPI_MOSI SPI_CLK SPI_IRQ TEST1 BlueNRG-MS VBAT 3 TEST2 TEST3 TEST4 RESET N SMPSF ILT1 NO_SMPS SMPSF ILT2 VDD1V 2 TEST10 SPI_CS SPI_MISO 3V3 1 2 3 4 5 6 7 TEST4 8 MOSI CLK IRQ TEST1 VBAT 3 2 Jumper2 VDD U1 100p_0402_CO G 33 2 R6 nc C4 150n_0402_ X5R 3 Solder a 10u_0805 between 1or a 0R0_0805 between 1- 3 VBAT 1 J3 HEADER 5X2 2 R5 nc C3 1 D1 22p_0402_CO G U2 1 R4 nc CONN 1 3 5 7 9 C2 100n_0402_ X7R 25 26 NO_SMPS 27 28 29 TEST10 30 CSN 31 MISO 32 1 R3 nc 2 4 6 8 10 C1 1u_0402_ X5R RST nS TEST5 TEST4 TEST6 TEST7 VDD 1 J1 Male Connector 2x5 Schematic diagram STEVAL-IDB005V1D Schematic diagram Figure 1: STEVAL-IDB005V1D circuit schematic STEVAL-IDB005V1D 2 Revision history Revision history Table 1: Document revision history Date Version Changes 17-Dec-2015 1 Initial release. DocID028757 Rev 1 3/4 STEVAL-IDB005V1D IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of Purchasers’ products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product. ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document. © 2015 STMicroelectronics – All rights reserved 4/4 DocID028757 Rev 1