Product Overview NCN6804: Smart Card Interface, Dual For complete documentation, see the data sheet Product Description The NCN6804 is a dual interface IC with serial control. It is dedicated for Smart Card/Secure Access Module (SAM) reader/writer applications. It allows the management of two external ISO/EMV cards (Class A, B or C). An SPI bus is used to control and configure the dual interface. The cards are controlled in a multiplexed mode. Two NCN6804 devices (four smart card interfaces) can share one single control bus thanks to a dedicated hardware address pin (S1). An accurate protection system guarantees timely and controlled shutdown in the case of external error conditions. This device is an enhanced version of the NCN6004A, more compact, more flexible and fully compatible with the NCN6001, its single interface counterpart version. It is fully compatible with ISO 7816-3, EMV and GIE-CB standards. Features • • • • • • • • • Dual Smart Card / SAM Interface with SPI Programming Bus Fully Compatible with ISO 7816-3, EMV and GIE-CB Standards One Protected Bidirectional Buffered I/O Line per Card Port Wide Power Supply Voltage Range: 2.7 V VDDPA/B & VDD 5.5 V Programmable/Independent CRD_VCC Supply for Each Smart Card Multiplexed Mode of Operating Handles 1.8 V, 3.0 V and 5.0 V Smart Cards Programmable Rise & Fall Card Clock Slopes (Slow & Fast Modes) Support up to 40 MHz Clock with Internal Programmable Clock (division ratio 1/1, 1/2, 1/4) Managed Independently for Each Card • Built-in Programmable CRD_CLK Stop Function handles Low State For more features, see the data sheet Applications End Products • Transaction Terminals • Banking Terminal Interfaces • Set Top Box Decoder • Pay TV / Set Top Box • POS / ATM Part Electrical Specifications Product NCN6804MNR2G Compliance Status VCC Min (V) VCC Max (V) IT Typ (mA) II(standby) Max (µA) fClock Max (MHz) Package Type Pb-free Active 2.7 5.5 0.1 100 40 QFN-32 Halide free Application Diagram For more information please contact your local sales support at www.onsemi.com Created on: 6/30/2016