STSW-STPM001 STPM32/33/34 evaluation software Data brief Features Description The STPM3x evaluation software is a graphical user interface to read, configure and calibrate the STPM3x energy metering ICs, suitable for parallel and USB hardware interfaces and for the UART interface. The application has a unique work area where the user can read device registers and write configuration and calibration parameters. The application parameters (such as sensor sensitivity, AFE parameters) of a selected device can be configured to return measured power, current and voltage. Data acquisition can be set to read one or more data samples from the device, and the same data can be output in table format and saved as an excel file. Wizard tools are provided to guide the user during the application design and to automatically calibrate the device. The current session data can be saved in a project at any time; an existing project can be opened or a new project can be created. Read and configure STPM3x devices Suitable for parallel and USB dongles and UART interfaces Single read or sampling available Automatic conversion of registers reading voltage, current, power and energy values Application design wizard for target ratings Automatic calibration procedure for: Amplitude Phase shift Power offset Application and configuration can be saved to file and loaded from it Based on .NET 2.0 framework December 2015 DocID028707 Rev 1 For further information contact your local STMicroelectronics sales office 1/3 www.st.com Revision history 1 STSW-STPM001 Revision history Table 1: Document revision history 2/3 Date Version Changes 01-Dec-2015 1 Initial release. DocID028707 Rev 1 STSW-STPM001 IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of Purchasers’ products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product. ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document. © 2015 STMicroelectronics – All rights reserved DocID028707 Rev 1 3/3