MiniProg3 Target Board Connector SAMTEC 2x5 .050” Shrouded Micro Header FTSH-105-01-L-DV-K http://www.samtec.com/ftppub/pdf/FTSH_SMT.PDF http://www.samtec.com/ftppub/cpdf/FTSH-1XX-XX-XXX-DV-XXX-MKT-sht3.pdf Top View VDDIO1 Recommended PCB Footprint 1 2 3 4 SWD CLK (P1.1) VSS 5 6 SWV / TDO (Optional* – P1.3) VSS 7 8 TDI (Optional* –P1.4) 9 10 VSS VSS + + .050 [1.27] XRES *No Connect Optional Pins if not Used EWB V1.1 .270 [6.86] SWD Data (P1.0) .110 [2.80] .029 [.74] inch [mm] MiniProg3 Programmer Connector SAMTEC .050” Dual Row Socket FFSD-05-D-06.00-01-N (Double End) http://www.samtec.com/ftppub/pdf/FFSD.PDF Standard Target 1 2 3 4 5 6 7 8 9 10 6 inches in length Pin 1 (red) Pin 10 Note Keying USB Cable Miniprog3 (CY8CKIT-002) EWB V1.1 MiniProg3 Programmer Custom Connector Cut Ribbon Cable at Connector (or use Single End Assembly) to Create a Custom Target Connector Attachment 1. VDDIO1 2. SWD Data 3. Vss 4. SWD Clock 5. Vss 6. TDO* 7. Vss 8. TDI* 9. Vss 10. XRES SAMTEC .050” Dual Row Socket FFSD-05-D-06.00-01-N (Double End) http://www.samtec.com/ftppub/pdf/FFSD.PDF 6 inches in length Pin 1 (red) Pin 10 * Optional USB Cable Miniprog3 (CY8CKIT-002) EWB V1.1