PROPRIETARY INFORMATION: Information contained in this drawing is confidential. Copying, distributing or use in any matter, other than that specified by IRONWOOD ELECTRONICS, INC., is strictly prohibited and may be unlawful. If you have received this drawing in error, please destroy or return to IRONWOOD ELECTRONICS, INC. at the address listed below. 27.6mm [1.085"] 21X23 Rev ** 24.8mm [0.975"] Top View Bottom View McMaster/Carr 91185A558 17.6mm [0.693"] RoHS COMPLIANT CY8C21002-24PVXI Description: CY3250-21X23 POD SSOP56 OCD (CY8C21002-24PVXI). Hirose cable connector with retension mechanism included. Compatible with: XT-PSoC-15-20H-10-01 - Flex cable (to ICE cube) Compatible with the following Non-QFN feet: C5116 - SOIC8 C6822 - SOIC16 foot C3845 - SSOP20 foot 3.6mm [0.140"] MGA (female Mini grid array receptacle) Side View 1 Page:____of 2 EA-8C21023-NQ-01 Drawing © 2006 IRONWOOD ELECTRONICS, INC. PO BOX21151 ST. PAUL, MN 55121 Tele: (651) 452-8100 www.ironwoodelectronics.com Status: 3:1 Scale:___ Rev: C Drawing: M. Tully Date: 8/1/06 File: EA-8C21023-NQ-01 Dwg Modified: 8/17/06, MT Tolerances: diameters ±0.03mm [±0.001”], PCB perimeters ±0.13mm [±0.005”], PCB thicknesses ±0.18mm [±0.007"], pitches (from true position) ±0.08mm [±0.003"], all other tolerances ±0.13mm [±0.005”] unless stated otherwise. Materials and specifications are subject to change without notice. POD clearance, with respect to center of target pattern 1.085" X Y To ICE Pod McMaster/Carr 91185A558 Flex Cable 0.575" 0.975" A Pod B C Foot Pod perimeter Foot Part number Description C5116 SOIC 8 foot C6822 C3845 Mask required A B C X no 0.845" 0.270" 0.245" 0.622" 0.513" SOIC16 foot no 0.845" 0.270" 0.245" 0.596" 0.488" SSOP 20 foot no 0.845" 0.270" 0.265" 0.621" 0.465" center of target land pattern (SOIC16 shown) Y 2 Page:____of 2 EA-8C21023-NQ-01 Drawing © 2006 IRONWOOD ELECTRONICS, INC. PO BOX21151 ST. PAUL, MN 55121 Tele: (651) 452-8100 www.ironwoodelectronics.com Status: 3:1 Scale:___ Rev: C Drawing: M. Tully Date: 8/1/06 File: EA-8C21023-NQ-01 Dwg Modified: 8/17/06, MT Tolerances: diameters ±0.03mm [±0.001”], PCB perimeters ±0.13mm [±0.005”], PCB thicknesses ±0.18mm [±0.007"], pitches (from true position) ±0.08mm [±0.003"], all other tolerances ±0.13mm [±0.005”] unless stated otherwise. Materials and specifications are subject to change without notice.