HN7G05FU TOSHIBA Multichip Discrete Device HN7G05FU Power Management Switch Applications, Inverter Circuit Applications, Driver Circuit Applications and Interface Circuit Applications Unit: mm Q1 (transistor): RN2301 equivalent Q2 (MOSFET): 2SK1830 equivalent Q1 (Transistor) Absolute Maximum Ratings (Ta = 25°C) Characteristic Symbol Rating Unit Collector-base voltage VCBO −50 V Collector-emitter voltage VCEO −50 V Emitter-base voltage VEBO −10 V IC −100 mA Collector current Q2 (MOSFET) Absolute Maximum Ratings (Ta = 25°C) Characteristic Symbol Rating Unit Drain-source voltage VDS 20 V Gate-source voltage VGSS 10 V ID 50 mA Symbol Rating Unit P (Note 1) 200 mW Tj 150 °C Tstg −55~150 °C Drain current JEDEC ― JEITA ― TOSHIBA 2-2J1E Weight: 0.0068 g (typ.) Marking Q1, Q2 Common Ratings (Ta = 25°C) Characteristic Power dissipation Junction temperature Storage temperature range Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). 60 Equivalent Circuit (top view) 6 5 Q2 Q1 1 4 2 3 Note 1: Total rating 1 2007-11-01 HN7G05FU Q1 (Transistor) Electrical Characteristics (Ta = 25°C) Characteristic Collector cutoff current Emitter cutoff current Symbol Test Condition Min Typ. Max Unit ICBO VCB = −50 V, IE = 0 ⎯ ⎯ −100 nA ICEO VCE = −50 V, IE = 0 ⎯ ⎯ −500 nA IEBO VEB = −5 V, IC = 0 −0.82 ⎯ −1.52 mA VCE = −5 V, IC = −10 mA 30 ⎯ ⎯ VCE (sat) IC = −5 mA, IB = −0.25 mA ⎯ −0.1 −0.3 V Input voltage (ON) VI(ON) VCE = −0.2 V, IC = −5 mA −1.1 ⎯ −2.0 V Input voltage (OFF) VI(OFF) VCE = −5 V, IC = −0.1 mA −1.0 ⎯ −1.5 V kΩ DC current gain Collector-emitter saturation voltage hFE Input resistor R1 ⎯ 3.29 4.7 6.11 Resistor ratio R1/R2 ⎯ 0.9 1.0 1.1 Test Condition Min Typ. Max Unit Q2 (MOSFET) Electrical Characteristics (Ta = 25°C) Characteristic Symbol IGSS VGS = 10 V, VDS = 0 ⎯ ⎯ 1 μA V (BR) DSS ID = 100 μA, VGS = 0 20 ⎯ ⎯ V IDSS VDS = 20 V, VGS = 0 ⎯ ⎯ 1 μA Vth VDS = 3 V, ID = 0.1 mA 0.5 ⎯ 1.5 V Forward transfer admittance ⎪Yfs⎪ VDS = 3 V, ID = 10 mA 20 ⎯ ⎯ mS Drain-source ON-resistance RDS (ON) ID = 10 mA VGS = 2.5 V ⎯ 20 40 Ω Gate leakage current Drain-source breakdown voltage Drain cutoff current Gate threshold voltage 2 2007-11-01 HN7G05FU Q1 (Transistor) 3 2007-11-01 HN7G05FU Q2 (S-MOS) 4 2007-11-01 HN7G05FU Q1, Q2 common P* – Ta POWER DISSIPATION PC (mW) 400 300 200 100 0 0 25 50 75 100 AMBIENT TEMPERATURE 125 150 175 Ta (°C) *:Total rating 5 2007-11-01 HN7G05FU RESTRICTIONS ON PRODUCT USE 20070701-EN GENERAL • The information contained herein is subject to change without notice. • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2007-11-01