RFM04U6P TOSHIBA Field Effect Transistor Silicon N Channel MOS Type RFM04U6P VHF- and UHF-band Amplifier Applications Unit: mm (Note)The TOSHIBA products listed in this document are intended for high frequency Power Amplifier of telecommunications equipment.These TOSHIBA products are neither intended nor warranted for any other use.Do not use these TOSHIBA products listed in this document except for high frequency Power Amplifier of telecommunications equipment. • Output power: PO = 4.3W (typ) • Gain: GP = 13.3dB (typ) • Drain efficiency: ηD = 70% (typ) Absolute Maximum Ratings (Ta = 25°C) Characteristics Symbol Rating Unit Drain-source voltage VDSS 16 V Gain-source voltage VGSS 3 V ID 2 A Drain current Power dissipation PD (Note 1) 7 W Channel temperature Tch 150 °C Storage temperature range Tstg −45 to 150 °C PW-Mini JEDEC ― JEITA SC-62 TOSHIBA 2-5K1D Note: Using continuously under heavy loads (e.g. the application of high Weight: 0.05 g (typ.) temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Tc = 25°C (When mounted on a 0.4 mm glass epoxy PCB with heat sink) Marking Part No. (or abbreviation code) Ｗ Lot No. 1 Ｆ 2 3 1. Gate 2. Source 3. Drain Caution: This device is sensitive to electrostatic discharge. Please make enough tool and equipment earthed when you handle. 1 2009-11-03 RFM04U6P Electrical Characteristics (Ta = 25°C) Characteristics Symbol Test Condition Min Typ. Max Unit Drain cut-off current IDSS VDS = 10 V, VGS = 0 V ⎯ ⎯ 10 μA Gate-source leakage current IGSS VGS = 3 V ⎯ ⎯ 5 μA 1.2 V Threshold voltage Vth VDS = 6.0 V, ID = 0.5mA 0.2 0.7 Output power PO 4.3 ⎯ W ηD 55 70 ⎯ % Power gain GP VDS = 6.0 V, Iidle = 500 mA (VGS = adjust), f = 470 MHz, Pi = 200 mW, ZG = ZL = 50 Ω 3.5 Drain efficiency 12.4 13.3 ⎯ dB VDS = 6.0 V, PO = 4 W(Pi = adjust), Iidle = 500 mA (VGS = adjust), f = 470 MHz, VSWR LOAD 20:1 all phase ⎯ Load mismatch No degradation Note 2: These characteristic values are measured using measurement tools specified by Toshiba. Output Power Test Fixture (Test Condition: f = 470 MHz, VDS = 6.0 V, Iidle = 500 mA, Pi = 0.2 W) C5 C6 Pi ZG = 50 Ω PO L1 C1 C7 R1 L2 R2 C3 C4 ZL = 50 Ω C9 C8 VGS C1: 20 pF C2: 8 pF C3: 18 pF C4: 1 pF C5: 2200 pF C6: 2200 pF C7: 10000 pF C8: 2200 pF C9: 10000 pF C2 VDS L1: φ0.6 mm enamel wire, 5.5ID, 5T L2: φ0.6 mm enamel wire, 5.5ID, 7T R1: 6.8 kΩ R2: 56 Ω Line: 2mm 2 2009-11-03 RFM04U6P Po -Pi 7 ηD -Pi 80 f =470MHz Iidle=500mA 70 6 60 Drain effcieny ηD(%) 5 OUTPUT POWER Po(W) f =470MHz Iidle=500mA 4 3 2 40 30 Vds=7.2V 20 Vds=7.2V Vds=6.0V Vds=4.5V Vds=3.6V 1 50 Vds=6.0V 10 Vds=4.5V Vds=3.6V 0 0 0 0.05 0.1 0.15 0.2 0.25 0.3 0.35 0.4 0 0.05 0.1 INPUT POWER Pi(W) 0.15 Po -Pi 5 0.2 0.25 0.3 0.35 0.4 INPUT POWER Pi(W) ηD -Pi 80 f =470MHz Vds=6.0V f =470MHz Vds=6.0V 70 60 Drain effcieny ηD(%) OUTPUT POWER Po(W) 4 3 2 40 30 20 Iidle=700mA 1 50 Iidle=500mA Iidle=700mA Iidle=500mA 10 Iidle=300mA Iidle=300mA 0 0 0.05 0.1 0.15 0.2 0.25 0.3 0.35 0 0.4 0 0.05 0.1 INPUT POWER Pi(W) 0.15 0.25 0.3 0.35 0.4 Vds - Ids Vgs - Iidle 3 0.2 INPUT POWER Pi(W) 1.8 f =470MHz Vds=6.0V Vgs=1.0V Vgs=1.5V 1.6 Vgs=2V 2.5 1.4 1.2 Ids(A) Iidle(A) 2 1.5 1 1 0.8 0.6 0.4 0.5 0.2 0 0 0 0.5 1 1.5 2 2.5 3 0 GATE VOLTAGE Vgs(V) 2 4 6 8 10 DRAIN VOLTAGE Vds(V) 3 2009-11-03 RFM04U6P Coss -Vds Ciss -Vds 70 40 f =1MHz f =1MHz 60 37 50 Coss (pF) Ciss (pF) 34 31 40 30 28 20 10 25 0 2 4 6 8 10 12 14 0 16 2 4 6 8 10 12 14 16 Vds(V) Vds(V) Crss -Vds 6 f =1MHz 5 Crss (pF) 4 3 2 1 0 0 2 4 6 8 10 12 14 16 Vds(V) Note 3: These are only typical curves and devices are not necessarily guaranteed at these curves. 4 2009-11-03 RFM04U6P RESTRICTIONS ON PRODUCT USE • Toshiba Corporation, and its subsidiaries and affiliates (collectively “TOSHIBA”), reserve the right to make changes to the information in this document, and related hardware, software and systems (collectively “Product”) without notice. • This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with TOSHIBA’s written permission, reproduction is permissible only if reproduction is without alteration/omission. • Though TOSHIBA works continually to improve Product’s quality and reliability, Product can malfunction or fail. Customers are responsible for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and systems which minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily injury or damage to property, including data loss or corruption. Before customers use the Product, create designs including the Product, or incorporate the Product into their own applications, customers must also refer to and comply with (a) the latest versions of all relevant TOSHIBA information, including without limitation, this document, the specifications, the data sheets and application notes for Product and the precautions and conditions set forth in the “TOSHIBA Semiconductor Reliability Handbook” and (b) the instructions for the application with which the Product will be used with or for. Customers are solely responsible for all aspects of their own product design or applications, including but not limited to (a) determining the appropriateness of the use of this Product in such design or applications; (b) evaluating and determining the applicability of any information contained in this document, or in charts, diagrams, programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operating parameters for such designs and applications. TOSHIBA ASSUMES NO LIABILITY FOR CUSTOMERS’ PRODUCT DESIGN OR APPLICATIONS. • Product is intended for use in general electronics applications (e.g., computers, personal equipment, office equipment, measuring equipment, industrial robots and home electronics appliances) or for specific applications as expressly stated in this document. Product is neither intended nor warranted for use in equipment or systems that require extraordinarily high levels of quality and/or reliability and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage or serious public impact (“Unintended Use”). Unintended Use includes, without limitation, equipment used in nuclear facilities, equipment used in the aerospace industry, medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic signaling equipment, equipment used to control combustions or explosions, safety devices, elevators and escalators, devices related to electric power, and equipment used in finance-related fields. Do not use Product for Unintended Use unless specifically permitted in this document. • Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part. • Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any applicable laws or regulations. • The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to any intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise. • ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR LOSS, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND LOSS OF DATA, AND (2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO SALE, USE OF PRODUCT, OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT. • Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation, for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology products (mass destruction weapons). Product and related software and technology may be controlled under the Japanese Foreign Exchange and Foreign Trade Law and the U.S. Export Administration Regulations. Export and re-export of Product or related software or technology are strictly prohibited except in compliance with all applicable export laws and regulations. • Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product. Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances, including without limitation, the EU RoHS Directive. TOSHIBA assumes no liability for damages or losses occurring as a result of noncompliance with applicable laws and regulations. 5 2009-11-03