Order this document by MOC215/D SEMICONDUCTOR TECHNICAL DATA [CTR = 20% Min] Transistor Output (Low Input Current) [CTR = 50% Min] These devices consist of a gallium arsenide infrared emitting diode optically coupled to a monolithic silicon phototransistor detector, in a surface mountable, small outline, plastic package. They are ideally suited for high density applications, and eliminate the need for through–the–board mounting. [CTR = 100% Min] • Convenient Plastic SOIC–8 Surface Mountable Package Style Motorola Preferred Devices • Low LED Input Current Required, for Easier Logic Interfacing • Standard SOIC–8 Footprint, with 0.050″ Lead Spacing • Shipped in Tape and Reel, which Conforms to EIA Standard RS481A SMALL OUTLINE OPTOISOLATORS TRANSISTOR OUTPUT • Compatible with Dual Wave, Vapor Phase and IR Reflow Soldering • High Input–Output Isolation of 3000 Vac (rms) Guaranteed • UL Recognized File #E54915 Ordering Information: • To obtain MOC215, 216, 217 in Tape and Reel, add R2 suffix to device numbers: R2 = 2500 units on 13″ reel • To obtain MOC215, 216, 217 in quantities of 50 (shipped in sleeves) — No Suffix Marking Information: • MOC215 = 215 • MOC216 = 216 • MOC217 = 217 Applications: CASE 846–01, STYLE 1 PLASTIC • Low power Logic Circuits • Interfacing and coupling systems of different potentials and impedances • Telecommunications equipment • Portable electronics SCHEMATIC MAXIMUM RATINGS (TA = 25°C unless otherwise noted) Rating Symbol Value Unit IF 60 mA IF(pk) 1.0 A Reverse Voltage VR 6.0 V LED Power Dissipation @ TA = 25°C Derate above 25°C PD 90 0.8 mW mW/°C Collector–Emitter Voltage VCEO 30 V Collector–Base Voltage VCBO 70 V Emitter–Collector Voltage VECO 7.0 V Collector Current — Continuous IC 150 mA Detector Power Dissipation @ TA = 25°C Derate above 25°C PD 150 1.76 mW mW/°C INPUT LED Forward Current — Continuous Forward Current — Peak (PW = 100 µs, 120 pps) OUTPUT TRANSISTOR 1 8 2 7 3 6 4 5 1. 2. 3. 4. 5. 6. 7. 8. LED ANODE LED CATHODE NO CONNECTION NO CONNECTION EMITTER COLLECTOR BASE NO CONNECTION NOTE: Thickness through insulation between input and output is ≥ 0.5 mm. Preferred devices are Motorola recommended choices for future use and best overall value. REV 1 Optoelectronics Device Data Motorola Motorola, Inc. 1995 1 MAXIMUM RATINGS — continued (TA = 25°C unless otherwise noted) Rating Symbol Value Unit VISO 3000 Vac(rms) Total Device Power Dissipation @ TA = 25°C Derate above 25°C PD 250 2.94 mW mW/°C Ambient Operating Temperature Range(3) Storage Temperature Range(3) TA Tstg — –55 to +100 °C –55 to +150 °C 260 °C TOTAL DEVICE Input–Output Isolation Voltage(1,2) (60 Hz, 1.0 sec. duration) Lead Soldering Temperature (1/16″ from case, 10 sec. duration) ELECTRICAL CHARACTERISTICS (TA = 25°C unless otherwise noted)(4) Symbol Min Typ(4) Max Unit — 1.05 1.3 V Reverse Leakage Current (VR = 6.0 V) VF IR — 0.1 100 mA Capacitance C — 18 — pF ICEO1 ICEO2 — 1.0 50 nA — 1.0 — µA V(BR)CEO V(BR)ECO 30 90 — V 7.0 7.8 — V CCE — 7.0 — pF IC (CTR)(5) 200 (20) 500 (50) 1.0 (100) 500(50) 800 (80) 1.3 (130) — — — µA (%) µA (%) mA (%) VCE(sat) ton — 0.35 0.4 V — 7.5 — µs — 5.7 — µs Rise Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω) toff tr — 3.2 — µs Fall Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω) tf — 4.7 — µs VISO RISO CISO 3000 1011 — — Vac(rms) — — Ω — 0.2 — pF Characteristic INPUT LED Forward Voltage (IF = 1.0 mA) OUTPUT TRANSISTOR Collector–Emitter Dark Current (VCE = 5.0 V, TA = 25°C) (VCE = 5.0 V, TA = 100°C) Collector–Emitter Breakdown Voltage (IC = 100 µA) Emitter–Collector Breakdown Voltage (IE = 100 µA) Collector–Emitter Capacitance (f = 1.0 MHz, VCE = 0) COUPLED Output Collector Current (IF = 1.0 mA, VCE = 5.0 V) MOC215 MOC216 MOC217 Collector–Emitter Saturation Voltage (IC = 100 µA, IF = 1.0 mA) Turn–On Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω) Turn–Off Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω) Input–Output Isolation Voltage (f = 60 Hz, t = 1.0 sec.)(1,2) Isolation Resistance (VI–O = 500 V)(2) Isolation Capacitance (VI–O = 0, f = 1.0 MHz)(2) 1. 2. 3. 4. 5. 2 Input–Output Isolation Voltage, VISO, is an internal device dielectric breakdown rating. For this test, pins 1 and 2 are common, and pins 5, 6 and 7 are common. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions. Always design to the specified minimum/maximum electrical limits (where applicable). Current Transfer Ratio (CTR) = IC/IF x 100%. Motorola Optoelectronics Device Data IC, OUTPUT COLLECTOR CURRENT (NORMALIZED) TYPICAL CHARACTERISTICS VF , FORWARD VOLTAGE (VOLTS) 2 PULSE ONLY PULSE OR DC 1.8 1.6 1.4 TA = – 55°C 1.2 25°C 1 100°C 1 10 100 IF, LED FORWARD CURRENT (mA) 10 NORMALIZED TO: IF = 1 mA 1 0.1 0.001 1000 IF = 1 mA 1.6 MOC217 1.4 1.2 1 MOC216 0.8 MOC215 0.6 0.4 0.2 ICEO, COLLECTOR–EMITTER DARK CURRENT (NORMALIZED) 0 0 1 2 3 4 5 6 7 8 9 10 2 5 10 NORMALIZED TO: TA = 25°C 1 0.1 –60 –40 –20 0 20 40 60 80 VCE, COLLECTOR–EMITTER VOLTAGE (VOLTS) TA, AMBIENT TEMPERATURE (°C) Figure 3. Output Current versus Collector–Emitter Voltage Figure 4. Output Current versus Ambient Temperature 100 120 20 NORMALIZED TO: VCE = 10 V TA = 25°C 100 18 C, CAPACITANCE (pF) I C, OUTPUT COLLECTOR CURRENT (mA) 2 1.8 0.1 0.2 0.5 1 IF, LED INPUT CURRENT (mA) Figure 2. Output Current versus Input Current I C, OUTPUT COLLECTOR CURRENT (NORMALIZED) Figure 1. LED Forward Voltage versus Forward Current 0.05 10 VCE = 30 V 1 10 V 20 40 60 80 TA, AMBIENT TEMPERATURE (°C) 100 Figure 5. Dark Current versus Ambient Temperature Motorola Optoelectronics Device Data f = 1 MHz 14 12 10 8 CCE 6 4 0.1 0 CLED 16 2 0.01 0.1 1 10 100 V, VOLTAGE (VOLTS) Figure 6. Capacitance versus Voltage 3 PACKAGE DIMENSIONS –A– 8 5 K 1 4 D 8 PL 0.13 (0.005) G –T– NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. B SEATING PLANE M T A M C 0.038 (0.0015) H J DIM A B C D G H J K INCHES MIN MAX 0.182 0.202 0.144 0.164 0.123 0.143 0.011 0.021 0.050 BSC 0.003 0.008 0.006 0.010 0.224 0.244 STYLE 1: PIN 1. 2. 3. 4. 5. 6. 7. 8. MILLIMETERS MIN MAX 4.63 5.13 3.66 4.16 3.13 3.63 0.28 0.53 1.27 BSC 0.08 0.20 0.16 0.25 5.69 6.19 ANODE CATHODE NC NC EMITTER COLLECTOR BASE NC CASE 846–01 ISSUE B Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters can and do vary in different applications. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. How to reach us: USA / EUROPE: Motorola Literature Distribution; P.O. Box 20912; Phoenix, Arizona 85036. 1–800–441–2447 JAPAN: Nippon Motorola Ltd.; Tatsumi–SPD–JLDC, Toshikatsu Otsuki, 6F Seibu–Butsuryu–Center, 3–14–2 Tatsumi Koto–Ku, Tokyo 135, Japan. 03–3521–8315 MFAX: [email protected] – TOUCHTONE (602) 244–6609 INTERNET: http://Design–NET.com HONG KONG: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 4 ◊ *MOC215/D* Motorola Optoelectronics Device Data MOC215/D