M54HC04 M74HC04 HEX INVERTER . . . . . . . . HIGH SPEED tPD = 6 ns (TYP.) AT VCC = 5 V LOW POWER DISSIPATION ICC = 1 µA (MAX.) AT TA = 25 °C HIGH NOISE IMMUNITY VNIH = VNIL = 28 % VCC (MIN.) OUTPUT DRIVE CAPABILITY 10 LSTTL LOADS SYMMETRICAL OUTPUT IMPEDANCE IOH = IOL = 4 mA (MIN.) BALANCED PROPAGATION DELAYS tPLH = tPHL WIDE OPERATING VOLTAGE RANGE VCC (OPR) = 2 V TO 6 V PIN AND FUNCTION COMPATIBLE WITH 54/74LS04 B1R (Plastic Package) F1R (Ceramic Package) M1R (Micro Package) C1R (Chip Carrier) ORDER CODES : M54HC04F1R M74HC04M1R M74HC04B1R M74HC04C1R PIN CONNECTIONS (top view) DESCRIPTION The M54/74HC04 is a high speed CMOS HEX INVERTER fabricated in silicon gate C2MOS technology. It has the same high speed performance of LSTTL combined with true CMOS low power consumption. The internal circuit is composed of 3 stages including buffer output, which enables high noise immunity and stable output. All inputs are equipped with circuits against static discharge and transient excess voltage. INPUT AND OUTPUT EQUIVALENT CIRCUIT NC = No Internal Connection December 1992 1/9 M54/M74HC04 TRUTH TABLE IEC LOGIC SYMBOL A Y L H H L PIN DESCRIPTION PIN No 1, 3, 5, 9, 11, 13 2, 4, 6, 8, 10, 12 SYMBOL 1A to 6A NAME AND FUNCTION Data Inputs 1Y to 6Y Data Outputs 7 GND Ground (0V) 14 VCC Positive Supply Voltage LOGIC DIAGRAM (Per Gate) ABSOLUTE MAXIMUM RATINGS Symbol ICC Value Unit VCC VI Supply Voltage DC Input Voltage Parameter -0.5 to +7 -0.5 to VCC + 0.5 V V VO DC Output Voltage -0.5 to VCC + 0.5 V IIK DC Input Diode Current ± 20 mA IOK DC Output Diode Current ± 20 mA IO or IGND DC Output Source Sink Current Per Output Pin DC VCC or Ground Current ± 25 ± 50 mA mA PD Power Dissipation 500 (*) mW Tstg TL Storage Temperature Lead Temperature (10 sec) -65 to +150 300 o o C C Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these condition isnotimplied. (*) 500 mW: ≅ 65 oC derate to 300 mW by 10mW/oC: 65 oC to 85 oC 2/9 M54/M74HC04 RECOMMENDED OPERATING CONDITIONS Symbol Parameter Value Unit V V VCC VI Supply Voltage Input Voltage 2 to 6 0 to VCC VO Output Voltage 0 to VCC Top tr, tf Operating Temperature: M54HC Series M74HC Series Input Rise and Fall Time V o -55 to +125 -40 to +85 0 to 1000 VCC = 2 V VCC = 4.5 V 0 to 500 VCC = 6 V 0 to 400 C C ns o DC SPECIFICATIONS Test Conditions Symbol VIH V IL V OH VOL Parameter High Level Input Voltage Low Level Input Voltage High Level Output Voltage Low Level Output Voltage VCC (V) 2.0 Min. 1.5 4.5 3.15 6.0 2.0 4.2 6.0 2.0 ICC Quiescent Supply Current Max. -40 to 85 oC -55 to 125 oC 74HC 54HC Min. 1.5 Max. 3.15 Min. 1.5 4.2 4.2 0.5 0.5 1.35 1.35 1.35 1.8 2.0 1.9 1.9 4.5 4.4 4.4 6.0 4.5 5.9 4.18 6.0 4.31 5.9 4.13 5.9 4.10 6.0 IO=-5.2 mA 5.68 5.8 5.63 5.60 6.0 6.0 V 1.8 1.9 4.4 2.0 4.5 V 0.5 1.8 Unit Max. 3.15 VI = IO=-20 µA VIH or V IL IO=-4.0 mA 4.5 4.5 6.0 Input Leakage Current Typ. 4.5 6.0 II Value TA = 25 oC 54HC and 74HC V 0.0 0.0 0.1 0.1 0.1 0.1 0.1 0.1 0.0 0.1 0.1 0.1 0.17 0.18 0.26 0.26 0.33 0.33 0.40 0.40 VI = VCC or GND ±0.1 ±1 ±1 µA VI = VCC or GND 1 10 20 µA VI = IO= 20 µA VIH or V IL IO= 4.0 mA IO= 5.2 mA V 3/9 M54/M74HC04 AC ELECTRICAL CHARACTERISTICS (C L = 50 pF, Input t r = tf = 6 ns) Test Conditions Symbol Parameter tTLH tTHL Output Transition Time tPLH tPHL Propagation Delay Time Value o VCC (V) TA = 25 C 54HC and 74HC Min. Typ. Max. -40 to 85 oC -55 to 125 oC 74HC 54HC Min. Max. Min. Max. 2.0 30 75 95 110 4.5 6.0 8 7 15 13 19 16 22 19 2.0 27 75 95 110 4.5 9 15 19 22 6.0 8 13 16 19 10 10 10 CIN Input Capacitance 5 CPD (*) Power Dissipation Capacitance 22 Unit ns ns pF pF (*) CPD is defined as the value of the IC’s internal equivalent capacitance which is calculated from the operating current consumption without load. (Refer to Test Circuit). Average operting current can be obtained by the following equation. ICC(opr) = CPD •VCC •fIN + ICC/6 (per Gate) SWITCHING CHARACTERISTICS TEST CIRCUIT TEST CIRCUIT ICC (Opr.) INPUT WAVEFORM IS THE SAME AS THAT IN CASE OF SWITCHING CHARACTERISTICS TEST. 4/9 M54/M74HC04 Plastic DIP14 MECHANICAL DATA mm DIM. MIN. a1 0.51 B 1.39 TYP. inch MAX. MIN. TYP. MAX. 0.020 1.65 0.055 0.065 b 0.5 0.020 b1 0.25 0.010 D 20 0.787 E 8.5 0.335 e 2.54 0.100 e3 15.24 0.600 F 7.1 0.280 I 5.1 0.201 L Z 3.3 1.27 0.130 2.54 0.050 0.100 P001A 5/9 M54/M74HC04 Ceramic DIP14/1 MECHANICAL DATA mm DIM. MIN. TYP. inch MAX. MIN. TYP. MAX. A 20 0.787 B 7.0 0.276 D E 3.3 0.130 0.38 e3 0.015 15.24 0.600 F 2.29 2.79 0.090 0.110 G 0.4 0.55 0.016 0.022 H 1.17 1.52 0.046 0.060 L 0.22 0.31 0.009 0.012 M 1.52 2.54 0.060 0.100 N P Q 10.3 7.8 8.05 5.08 0.406 0.307 0.317 0.200 P053C 6/9 M54/M74HC04 SO14 MECHANICAL DATA mm DIM. MIN. TYP. A a1 inch MAX. MIN. TYP. 1.75 0.1 0.068 0.2 a2 MAX. 0.003 0.007 1.65 0.064 b 0.35 0.46 0.013 0.018 b1 0.19 0.25 0.007 0.010 C 0.5 0.019 c1 45° (typ.) D 8.55 E 5.8 8.75 0.336 6.2 0.228 0.344 0.244 e 1.27 0.050 e3 7.62 0.300 F 3.8 4.0 0.149 0.157 G 4.6 5.3 0.181 0.208 L 0.5 1.27 0.019 0.050 M S 0.68 0.026 8° (max.) P013G 7/9 M54/M74HC04 PLCC20 MECHANICAL DATA mm DIM. MIN. TYP. inch MAX. MIN. TYP. MAX. A 9.78 10.03 0.385 0.395 B 8.89 9.04 0.350 0.356 D 4.2 4.57 0.165 0.180 d1 2.54 0.100 d2 0.56 0.022 E 7.37 8.38 0.290 0.330 e 1.27 0.050 e3 5.08 0.200 F 0.38 0.015 G 0.101 0.004 M 1.27 0.050 M1 1.14 0.045 P027A 8/9 M54/M74HC04 Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsability for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may results from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use ascritical components in life support devices or systems without express written approval of SGS-THOMSON Microelectonics. 1994 SGS-THOMSON Microelectronics - All Rights Reserved SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A 9/9