STMICROELECTRONICS ST72753L4

ST72753
R
8-BIT MCU FOR MONITORS WITH UP TO 32K ROM, 1K RAM, ADC,
TIMER, SYNC, PWM/BRM, DDC/DMA & I2C
BRIEF DATA
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
User ROM/OTP: up to 32 Kbytes
Data RAM: up to 1 Kbytes (256 bytes stack)
8 MHz Maximum Internal Clock Frequency in
fast mode, 4 MHz in normal mode
Run, Wait and Halt CPU modes
Sync Processor for Mode Recognition, power
management and composite video blanking,
clamping
and
free-running
frequency
generation.
– Corrector mode
– Analyzer mode
Fast I2C Multi Master Interface
DDC Bus Interface fully compliant with DDC1,
2B, 2B+, 2AB, 2Bi standards
18 I/O lines
– 1 high current I/O (10 mA)
– Up to 4 high voltage outputs (9V)
16-bit timer with 2 input captures and 2 output
compare functions (with 1 output pin)
8-bit Analog to Digital Converter with 4
channels on port B
8 10-bit PWM/BRM Digital to Analog outputs
One 12-bit PWM/BRM Digital to Analog output
Master Reset and Power on/off reset1
Programmable Watchdog for system reliability
34-pin Shrink Dual In line Plastic package
Fully static operation
0 to + 70 oC Operating Temperature Range
4.0V to 5.5V supply operating range
24 MHz Quartz Oscillator
63 basic instructions/17 main address modes
8x8 unsigned multiply instruction
True bit manipulation
Versatile Development Tools (DOS and
Windows) including assembler, linker, Ccompiler, archiver, source level debugger,
programmer, and hardware emulator
PSO34
See Ordering Information at the end of the Document
Device Summary
Features
ROM
(bytes)
RAM
(bytes)
ADC
Timer
I2C Bus
DDC/DMA
Sync
PWM
I/O
OTP
Device
ST72753L6
ST72753L5
ST72753L4
32K
24K
16K
1K
768
512
4 channels
1
one multimaster
yes
yes
6
18
ST72T752L6M1
Note 1: Power On/Off reset not implemented in
this revision.
April 1998
This is preliminary information on a new product in development or undergoing evaluation. Details are subject to change without notice.
1/3
1
ST72753
1 GENERAL DESCRIPTION
1.1 INTRODUCTION
The ST72753 is a HCMOS microcontroller unit
(MCU) from the ST7 family with dedicated peripherals for Monitor applications.
It is based around an industry standard 8-bit core
and offers an enhanced instruction set. The processor runs with an external clock at 24 MHz with
a 5V supply. Due to the fully static design of this
device, operation down to DC is possible. Under
software control the ST72753 can be placed in
WAIT or HALT mode thus reducing power consumption. The enhanced instruction set and addressing modes afford real programming potential.
In addition to standard 8-bit data management the
ST7 features true bit manipulation, 8x8 unsigned
multiplication and indirect addressing modes.
The device includes an on-chip oscillator, CPU,
Sync Processor for video timing & Vfback analysis, up to 32K ROM, up to 1K RAM, I/O, a timer
with 2 input captures and 2 output compares, a 4channel Analog to Digital Converter, DDC/DMA,
I2C multi Master, Watchdog Reset, and six 10-bit
PWM/BRM outputs for analog DC control of external functions.
Figure 1. ST72753 Block Diagram
PORT A
PA4-PA6 (HV)
PA7/BLANKOUT
Up to 32K Bytes
ROM/
EPROM/OTP
ADC
AIN 0..2, AIN7
PB7/AIN7
PB1..2/ AIN1..2
PB0/ VFBACK/AIN0
PORT B
Up to 1K Bytes
DDC DMA
I²C
SDAI
SCLD
DDC
SDAD
SCLI
ADDRESS / DATA BUSES
RAM
PORT C
OCMP
TIMER
WATCHDOG
INTERNAL
CLOCK
OSC /3 or 6
PWM/BRM
2/3
VFBACK
VSYNC
HFBACK
VSYNCO
CLAMPOUT
PORT D
HSYNCO
POWER ON/OFF
V DD V SS OSCIN OSCOUT
VSYNCI
HSYNCI
SYNC
PROCESSOR
CSYNCI
PCL
PCH
SP
X
Y
A
CC
8-BIT CORE
ALU
POWER
SUPPLY
RESET
H/CSYNC
CONTROL
PC6 (HC)
PC5/SDAI
PC4/SCLI
PC3/SDAD
PC2/RX/SCLD
PC0/OCMP/HFBACK
PD6/CLAMPOUT
PD3/ITC
PD2/VSYNCO
PD1/HSYNCO
PD0/CSYNCI/ITA
DA1,DA6
ST72753
Notes:
Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no
responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third
parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights
of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice.
This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products
are not authorized for use as critical components in life support devices or systems without the express written approval
of SGS-THOMSON Microelectronics.
1998 SGS-THOMSON Microelectronics - All Rights Reserved.
Purchase of I2C Components by SGS-THOMSON Microelectronics conveys a license under the Philips I2C Patent. Rights to use these
components in an I2C system is granted provided that the system conforms to the I2C Standard Specification as defined by Philips.
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia - Brazil - Canada - China - France - Germany - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands - Singapore
Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.
3/3