TS339C,I,M MICROPOWER QUAD CMOS VOLTAGE COMPARATORS . . . . . .. . EXTREMELY LOW SUPPLY CURRENT : 9µA TYP / COMPARATOR WIDE SINGLE SUPPLY RANGE (3V TO 16V) OR DUAL SUPPLIES (±1.5V TO ±8V) EXTREMELY LOW INPUT BIAS CURRENT : 1pA TYP EXTREMELY LOW INPUT OFFSET CURRENT : 1pA TYP INPUT COMMON-MODE VOLTAGE RANGE INCLUDES GND HIGH INPUT IMPEDANCE : 1012Ω TYP FAST RESPONSE TIME : 1.5µs TYP FOR 5mV OVERDRIVE PIN-TO-PIN AND FUNCTIONALLY COMPATIBLE WITH BIPOLAR LM339 DESCRIPTION N DIP14 (Plastic Package) D SO14 (Plastic Micropackage) P TSSOP14 (Thin Shrink Small Outline Package) ORDER CODES The TS339 is a micropower CMOS quad voltage comparator with extremely low consumption of 9µA typ / comparator (20 times less than bipolar LM339). Similar performances are offered by the quad micropower comparator TS3704 with a pushpull CMOS output. Thus response times remain similar to the LM339. Part Number Temperature Range o o 0 C, +70 C TS339C o o o o TS339I -40 C, +125 C TS339M -55 C, +125 C Package N D P ● ● ● ● ● ● ● ● ● Example : TS339CN PIN CONNECTIONS (top view) 1 14 Output 3 Output 1 2 13 Output 4 12 V CC - Output 2 VCC + Inverting Input 1 4 - + 11 Non-inverting Input 4 Non-inverting Input 1 5 + - 10 Inverting Input 4 Inverting Input 2 6 - + 9 Non-inverting Input 3 7 + - 8 Inverting Input 3 Non-inverting Input 2 September 1998 3 1/6 TS339C,I,M SCHEMATIC DIAGRAM (for 1/4 TS339) VCC + T10 T1 T2 T9 T17 R1 T12 T11 Input - T3 T18 Input + T4 O utput T20 T13 T8 T19 T5 T14 T7 T15 T16 T6 VCC - MAXIMUM RATINGS Symbol VCC+ Parameter Value Unit Supply Voltage - (note 1) 18 V Vid Differential Input Voltage - (note 2) ±18 V Vi Input Voltage - (note 3) 18 V VO Output Voltage 18 V IO Output Current 20 mA Toper o Operating Free-Air Temperature Range C TS339C TS339I TS339M Tstg Notes : 1. 2. 3. 4. Storage Temperature Range 0 to +70 -40 to +125 -55 to +125 -65 to +150 o C All voltage values, except differential voltage, are with respect to network ground terminal. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. The magnitude of the input and the output voltages must never exceed the magnitude of the positive supply voltage. Short circuit from outputs to VCC+ can cause excessive heating and eventual destruction. OPERATING CONDITIONS Symbol VCC + Vicm 2/6 Parameter Supply Voltage Common Mode Input Voltage Range TS339C,I TS339M Value Unit 3 to 16 4 to 16 V 0 to VCC+ -1.5 V TS339C,I,M ELECTRICAL CHARACTERISTICS VCC+ = 5V, VCC- = 0V, Tamb = 25°C (unless otherwise specified) Symbol Vio Iio Iib Parameter Min. Input Offset Voltage - (note 1) + Vic = Vicm min., VCC = 5V to 10V Tmin. ≤ Tamb ≤ Tmax. Typ. Max. 1.4 5 6.5 mV Input Offset Current - (note 2) Vic = 2.5 V Tmin. ≤ Tamb ≤ Tmax. 1 Input Bias Current - (note 2) Vic = 2.5 V Tmin. ≤ Tamb ≤ Tmax. 1 pA 300 pA 600 VCC+ -1.2 + VCC -1.5 V Vicm Input Common Mode Voltage Range Tmin. ≤ Tamb ≤ Tmax. CMR Common-mode Rejection Ratio Vic = Vicm min. 75 Supply Voltage Rejection Ratio + VCC = +5V to +10V 85 High Level Output Current Vid = 1V, VOH = +5V Tmin. ≤ Tamb ≤ Tmax. 2 40 1000 Low Level Output Voltage Vid = -1V, IOL = 6mA Tmin. ≤ Tamb ≤ Tmax. 350 400 650 Supply Current (4 comparators) No load - Outputs low Tmin. ≤ Tamb ≤ Tmax. 36 80 100 SVR IOH VOL ICC tPLH tPHL tf Response Time Low to High Vic = 0V, f = 10kHz, RL = 5.1kΩ, CL = 15pF, Response Time High to Low Vic = 0V, f = 10kHz, RL = 5.1kΩ, CL = 15pF, Unit 0 to 0 to dB dB nA mV µA Overdrive = Overdrive = Overdrive = Overdrive = TTL Input 5mV 10mV 20mV 40mV 1.5 1.2 1.1 0.9 0.8 Overdrive = Overdrive = Overdrive = Overdrive = TTL Input 5mV 10mV 20mV 40mV 2.5 1.9 1.2 0.8 0.08 Fall Time f = 10kHz, CL = 15pF, R L = 5.1kΩ, Overdrive 50mV µs µs ns 25 Note : 1. The specified offset voltage is the maximun value required to drive the output up to 4.5V or down to 0.3V. 2. Maximum values including unavoidable inaccuracies of the industrial test. 3/6 TS339C,I,M PM-DIP14.EPS PACKAGE MECHANICAL DATA 14 PINS - PLASTIC DIP a1 B b b1 D E e e3 F i L Z 4/6 Min. 0.51 1.39 Millimeters Typ. Max. 1.65 Min. 0.020 0.055 0.5 0.25 Inches Typ. 0.065 0.020 0.010 20 0.787 8.5 2.54 15.24 0.335 0.100 0.600 7.1 5.1 0.280 0.201 3.3 1.27 Max. 0.130 2.54 0.050 0.100 DIP14.TBL Dimensions TS339C,I,M PM-SO14.EPS PACKAGE MECHANICAL DATA 14 PINS - PLASTIC MICROPACKAGE (SO) A a1 a2 b b1 C c1 D E e e3 F G L M S Min. Millimeters Typ. 0.1 0.35 0.19 Max. 1.75 0.2 1.6 0.46 0.25 Min. Inches Typ. 0.004 0.014 0.007 0.5 Max. 0.069 0.008 0.063 0.018 0.010 0.020 o 45 (typ.) 8.55 5.8 8.75 6.2 0.336 0.228 1.27 7.62 3.8 4.6 0.5 0.334 0.244 0.050 0.300 4.0 5.3 1.27 0.68 0.150 0.181 0.020 0.157 0.208 0.050 0.027 SO14.TBL Dimensions o 8 (max.) 5/6 TS339C,I,M PACKAGE MECHANICAL DATA 14 PINS - THIN SHRINK SMALL OUTLINE PACKAGE Dim. Millimeters Min. Typ. A Min. Typ. 1.20 A1 0.05 A2 0.80 b c D 4.90 Max. 0.05 0.15 0.01 1.05 0.031 0.19 0.30 0.007 0.15 0.09 0.20 0.003 0.012 5.10 0.192 4.50 0.169 8o 0o 0.75 0.09 E E1 Inches Max. 1.00 5.00 6.40 4.30 e 4.40 0o l 0.50 0.60 0.039 0.196 0.041 0.20 0.252 0.65 k 0.006 0.173 0.177 0.025 8o 0.0236 0.030 1998 STMicroelectronics – Printed in Italy – All Rights Reserved STMicroelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - France - Germany - Italy - Japan - Korea - Malaysia - Malta - Mexico - Morocco The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A. 6/6 ORDER CODE : Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publ ication supersedes and replaces all infor mation previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a trademark of STMicroelectronics