Pushbutton Switches Momentary Pushbutton Switches with LED LED Positions CAP TYPES NS & NL PB9 Series SPDT Contact Configuration Bottom View CAP STYLE Stand Cap PAPERBOARD NS0 NL0 NS1 NL1 NS2 NL2 Non LED Note: TS & TL TS_ Transparent Cap One-LED TL_ CUTAWAY Symbol (Unit) Red Yellow Green Blue Forward Voltage VF(V) 2.0 2.1 2.2 3.5 Forward Current IF(mA) 20 20 20 20 Permissible Loss PD(mW) 80 80 80 120 Luminous Intensity Iv(mcd) 60 50 60 600 Peak Wave Length λP(nm) 635 585 568 470 Reverse Voltage VR(V) 5 Reverse Current VR=5V (uA) 100 Soldering Temperature (°C) 260 for 5 seconds How to order: PB9 1 NS0 NS1 NS2 NL0 NL1 NL2 TS0 TS1 TS2 TL0 TL1 TL2 2 C E F B A D G H 1 2 3 CAP TYPE & STYLE: Small Cap without LED Small Cap with One-LED Small Cap with Two-LED Large Cap without LED Large Cap with One-LED Large Cap with Two-LED Transparent Small Cap without LED Transparent Small Cap with One-LED Transparent Small Cap with Two-LED Transparent Large Cap without LED Transparent Large Cap with One-LED Transparent Large Cap with Two-LED CAP COLORS (Only for NS & NL Cap): Red Yellow Green White Black Orange Blue Grey [email protected] The electrical specifications shown are determined at a basic temperature of 25°C. If the source voltage exceeds the rated of LED, a ballast resistor has to be connected in series with the LED. Attention: LED are electrostatic sensitive devices General Specifications: 4 3 Two-LED write area (Paperboard only for cap type TS & TL) LED CHARACTERISTICS Parameters P.C.B. Mounting Holes 00 LED COLORS: Without LED 0C 0E 0F 0G One-LED: Red Yellow Green Blue CC CE CF CG EC EE EF EG FC FE FF FG GC Two-LED (Left / Right): Red / Red Red / Yellow Red / Green Red / Blue Yellow / Red Yellow / Yellow Yellow / Green Yellow / Blue Green / Red Green / Yellow Green / Green Green / Blue Blue / Red GE GF GG Blue / Yellow Blue / Green Blue / Blue 4 LED TERMINAL & ELECTRODE DIRECTION: + o o - Bend (One-LED) o + - o Standard (One-LED) o - + o (One-LED) + - - + Standard (Two-LED) - + + - (Two-LED) - + - + (Two-LED) + - + - (Two-LED) 0 no code 2 no code 4 5 6 Standard: No Code + : anode - : cathode o : none this pin ELECTRICAL & MECHANICAL SPECIFICATIONS: » Circuit: SPDT » Current Rating: 12 mA » Voltage Rating: 24 VDC » Contact Resistance: 50 mΩ max. (initial) » Insulation Resistance: 100MΩ min. » Operating Force: 170±50 gf » Total Travel: 2.5±0.5 mm » Operating Life: 1,000,000 cycles min. » Soldering: 260 °C for 3 seconds » Operating Temperature: -10 °C ~ +60 °C » Function: Momentary MATERIALS » Cap: Acrylonitrile Butadine Styrene (ABS) » Case: Polyamide (PA) » Fixed Support: Stainless steel wire » Terminals: Phosphor bronze (PBS) with gold plating » Moving Contact: Phosphor bronze (PBS) with gold plating » Spring: Piano wire » LED: 3mm Diameter LED lamp www.greatecs.com