UNISONIC TECHNOLOGIES CO., LTD 3422 LINEAR INTEGRATED CIRCUIT HIGH PERFORMANCE DUAL BIPOLAR OPERATINAL AMPLIFIER SOP-8 DESCRIPTION The UTC 3422 is a dual high performances operational amplifier featuring speed of 25MHz and single supply operation from 3V ~ 36V. The UTC 3422 is therefore an enhanced replacement of standard dual operational amplifiers. DIP-8 FEATURES * Single Supply Operation: 3V ~ 36V * Dual Supply Operation: ±1.5V ~ ±18V * High Gain Bandwidth Product: 25MHz * High Slew Rate: 15V/μs * Low Voltage Noise: 14nV/√Hz * No Phase Inversion * ESD Tolerance: 2KV * Latch-Up Immunity ORDERING INFORMATION Ordering Number Lead Free 3422L-D08-T 3422L-S08-R 3422L-S08-T Halogen Free 3422G-D08-T 3422G-S08-R 3422G-S08-T www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., LTD Package Packing DIP-8 SOP-8 SOP-8 Tube Tape Reel Tube 1 of 6 QW-R105-029,Ba 3422 LINEAR INTEGRATED CIRCUIT PIN CONFIGURATION BLOCK DIAGRAM (1/2 Shown) 20μA 20μA ESD Vcc+ 130μA 250μA 130μA 600μA ESD Non Inverting Input Cc Inverting Input Output Vcc- UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 6 QW-R105-029,Ba 3422 LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL RATINGS UNIT Supply Voltage VCC ±18 ~ 36 V Differential Input Voltage (Note 1) VID ±36 V Input Voltage (Note 1) VIN ±18 V Output Short-Circuit Duration (Note 2) Infinite Maximum Power Dissipation (Note 2) PTOT 500 mW Operating Temperature TOPR -40 ~ +125 ℃ Junction Temperature TJ +150 ℃ Storage Temperature TSTG -65 ~ +150 ℃ Notes: 1. Either or both input voltages must not exceed the magnitude of VCC+ or VCC2. Power dissipation must be considered to ensure maximum junction temperature (TJ) is not exceeded OPERATING CONDITIONS PARAMETER Supply Voltage SYMBOL VCC UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw RATINGS 3 ~ 36 UNIT V 3 of 6 QW-R105-029,Ba 3422 LINEAR INTEGRATED CIRCUIT ELECTRICAL CHARACTERISTICS (Vcc+=15V, Vcc-=-15V, Ta=25℃, unless otherwise specified) PARAMETER Input Offset Voltage SYMBOL VIO Input Offset Voltage Drift Input Offset Current Input Bias Current △VIO IIO IIB Common Mode Input Voltage VICM Large Signal Voltage Gain AVD Output Voltage Swing Output Short Circuit Current Common Mode Rejection Ratio Supply Voltage Rejection Ratio Supply Current Slew Rate Gain Bandwith Product Unity Gain Bandwith ±VOPP IO TYP 2 3 100 VCC- to VCC+-1.8 32 20 13.4 13.4 MAX 2.5 3.5 2.5 65 650 mV μV/℃ nA nA V 100 13.9 -13.9 14 -14.7 UNIT V/mV -13.5 -14.1 V 3.7 25 25 0.15 37 37 0.2 mA Vic=-15V ~ +13.2V 80 100 dB SVR VCC+/ 90 105 dB ICC SR GBP B m Equivalent Input Noise Voltage eN Total Harmonic Distortion RL=2kΩ, VO=0V ~ +10V TMIN≤TA≤TMAX VCC+=+15V,VCC-=-15V, VOH RL=2kΩ VOL VOH VID=±1V RL=10kΩ VOL + VOH VCC =+5V, VCC =0V, RL=2kΩ VOL Source VID=±1V, VO=0V, Sink MIN CMR Phase Margin Channel Separation TEST CONDITIONS VCC+=+15V, VCC-=-15V VIC=0V, VO=0V TMIN≤TA≤TMAX + VCC =+5V, VCC =0V VIC=0V, VO=0V VIC=0V, VO=0V VIC=0V, VO=0V VCC-=+15V/-15V ~ +5V/-5V VCC+=+15V, VCC-=-15V VO=0V,no load, TMIN≤TA≤TMAX each amplifier VCC+=+5V,VCC-=0V VI =-10V~10V,CL=100pF,RL=2kΩ, AV=+1 f=100kHz, RL=2kΩ, CL=100pF Open loop RL=2kΩ RL=2kΩ, CL=100pF RS=100Ω, f=1kHz VO1/VO2 f=20Hz ~ 20kHz VCC=±15V, f=1kHz, AVCL=20dB, THD RL=600Ω, VO=3Vrms UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2.15 8 17 15 25 5 50 40 2.75 3 2.75 mA V/μs MHz MHz Degrees 120 nV √Hz dB 0.003 % 14 4 of 6 QW-R105-029,Ba 3422 LINEAR INTEGRATED CIRCUIT APPLICATIONS INFORMATION Output Voltage, Vo (V) Input Voltages, VIN+(V), VREF (V) UTC 3422 IN COMPARATOR APPLICATION The UTC 3422 is a dual bipolar operational amplifier offering a single supply operation from 3V ~ 36V with very good performances: medium speed (25MHz), unity gain stability and low noise. Most of operational amplifiers are not suited for comparator use because of low transition speed, output signal incompatible with standard logics level and mainly, phase inversion. The phase inversion occures when a strong differential signal is applied to the device inputs. The output level is then inverted and shows a wrong logic state. The UTC 3422 does not present this problematic behaviour. Figure 1 shows basic comparator application. Figure 2 shows the curves of the device response in standard comparator configuration without external components. Transition speed : Typical transition speed under a single 5V supply voltage is about 2μs from 50mV overdrive. VOH(MIN). is 3.7V and VOL(MAX). is 0.2V (2kΩ load) making it compatible with standard logic families. Figure 3 shows output signal transition for a 50mV input signal overdrive respectively of 3μs. Figure 4 shows output signal transition for a 250mV input signal overdrive respectively of 1μs. Figure.1 Basic Comparator Application Figure.2 Operating Conditions 2.0 1.0 0.5 0 VIN+ 6 3μs 4 2 Vo 0 Time (0.5μs/div) Figure.3 Transition Speed @ 50mV Overdrive UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw Input Voltages, VIN+ (V) 1.5 Output Voltage, Vo (V) Input Voltages, VIN+ (V) 1.5 VREF VREF 1.0 0.5 0 VIN+ 6 1μs 4 2 Vo Output Voltage, Vo (V) 2.0 0 Time (0.5μs/div) Figure.4 Transition Speed @ 250mV Overdrive 5 of 6 QW-R105-029,Ba 3422 LINEAR INTEGRATED CIRCUIT APPLICATIONS INFORMATION(Cont.) Input & Output Voltages, VID(V), Vo (V) Input & Output Voltages, VID(V), Vo (V) PHASE INVERSION The UTC 3422 keeps the right output level thanks to its specific input structures at high differential input voltage. The advantage is obvious on the following figures and can be also an advantage in linear use when saturation might occure. Figure 5 shows the behaviour in follower stage with saturation output of UTC 3422. Figure 6 shows the saturation behaviour with 15MHz standard operational amplifier. Figure.5 Behaviour With UTC3422 Figure.6 Saturation Behaviour With 15MHz Standard Operational Amplifier UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 6 QW-R105-029,Ba