UTC-IC MC34119L-P08-R

UNISONIC TECHNOLOGIES CO., LTD
MC34119
LINEAR INTEGRATED CIRCUIT
LOW POWER AUDIO
AMPLIFIER
„
DESCRIPTION
The UTC MC34119 is a low power audio amplifier IC intended for
the telephone applications, such as in speakerphones. It provides
differential speaker outputs to maximize output swing at low supply
voltages. Coupling capacitor to the speaker is not required. Open
loop gain is 80dB, and the closed loop gain is set with two external
resistors. The Mute pin permits powering down and/or muting the
input signal.
„
FEATURES
* Wide operating supply voltage: VCC=2V~16V
* Low quiescent supply current (ICC=2.7mA, typ)
* Medium power output over 250mW at VCC=6V,
RL=32Ω, THD<10%
* Load impedance range (8Ω~100Ω)
* Low total harmonic distortion (0.5% typ)
* Mute function (ICC=65μA, typ)
* Minimum number of external parts required
„
ORDERING INFORMATION
Ordering Number
Lead Free
MC34119L-D08-T
MC34119L-S08-R
MC34119L-S08-T
MC34119L-P08-R
MC34119L-P08-T
Halogen Free
MC34119G-D08-T
MC34119G-S08-R
MC34119G-S08-T
MC34119G-P08-R
MC34119G-P08-T
www.unisonic.com.tw
Copyright © 2012 Unisonic Technologies Co., Ltd
Package
Packing
DIP-8
SOP-8
SOP-8
TSSOP-8
TSSOP-8
Tube
Tape Reel
Tube
Tape Reel
Tube
1 of 8
QW-R107-038,H
MC34119
„
PIN CONFIGURATION
„
PIN DESCRIPTION
PIN NO.
1
2
3
4
5
6
7
8
LINEAR INTEGRATED CIRCUIT
PIN NAME
DESCRIPTION
This pin can be used to power down the IC to converse power, or for muting, or both. When
Mute
at a logic “LOW” (less than 0.8V), the IC is enabled for normal operation. When at a logic
“HIGH” (2V to VCC), the IC is disabled. If Mute is open, that is equivalent to a logic “LOW”.
Ripple
A capacitor at this pin increase power supply rejection, and affects turn-on time. This pin
Rejection can be left open if the capacitor at pin 3 is sufficient.
Analog Ground for the amplifiers. A 1μF capacitor at this pin (with a 5μF capacitor at pin 2)
Input(+) provides 52dB( typ) of power supply rejection. Turn-on time of the circuit is affected by the
capacitor on this pin. This pin can be used as an alternative input.
Amplifier input. The input capacitor and resistor set low frequency roll-off and input
Input(-)
impedance. The feedback resistor is connected between this pin and output 1.
Output 1 Amplifier output 1. The DC level is about (VCC~0.7V)/2.
VCC
DC supply voltage is applied to this pin (VCC=2~16V).
GND
Ground pin.
Amplifier output 2. This signal is equal in amplitude, but 180°out of phase with that output 1,
Output 2
the DC level is about (Vcc~0.7V)/2.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 8
QW-R107-038,H
MC34119
„
LINEAR INTEGRATED CIRCUIT
BLOCK DIAGRAM
IN-
4
Amp 1
IN+
VCC
5
OUT1
8
OUT2
1
MUTE
3
6
Bias
2
7
RR
GND
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 8
QW-R107-038,H
MC34119
„
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATINGS (TA=25°C )
PARAMETER
SYMBOL
RATINGS
UNIT
Supply Voltage
VCC
-1~+18
V
±250
Output Current
IOUT
mA
Maximum Input, Ripple Rejection, Mute Pin Voltage
VIN
-1~+1
V
Applied Output Voltage (Output Pin When Disabled)
VOUT
-1~+1
V
Junction Temperature
TJ
+125
°C
Operating Temperature
TOPR
-20 ~ +85
°C
Storage Temperature
TSTG
-40 ~ +150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
„
RECOMMENDED OPERATION CONDITIONS (TA=25°C)
PARAMETER
Supply Voltage
Load Impedance
Peak Load Current
Differential Gain (5KHz Bandwidth)
Voltage at Mute
Ambient Temperature
„
SYMBOL
VCC
ZL
IL(PEAK)
ΔGV
VI(MUTE)
Ta
RATINGS
2~16
8~100
±200
UNIT
V
Ω
mA
dB
V
°C
0~46
0~VCC
-20~+70
ELECTRICAL CHARACTERISTICS (VCC=6V, TA=25°C, unless otherwise specified)
PARAMETER
DC PARAMETER
SYMBOL
Operating Current
Output Voltage
ICC
VOUT
Output Offset Voltage
Output High Level
Output Low Level
Input Bias Current
VO(OFF)
VOH
VOL
II(BIAS)
Equivalent Resistance
REQ
AC PARAMETER
Open Loop Gain of Amp. 1
Open Loop Gain of Amp. 2
GV1
GV2
Output Power
POUT
Total Harmonic Distortion
(f=1KHz)
THD
Gain Bandwidth Product
GBW
Power Supply Rejection
(VCC=6V, ΔVCC=3V)
RR
Muting
GV(MUTE)
TEST CONDITIONS
VCC=3V, Mute=0.8V
VCC=16V, Mute=0.8V
VCC=3V, Mute=2V
RL=16Ω, R1=75KΩ, VCC=3V
RL=16Ω, R1=75KΩ, VCC=6V
RL=16Ω, R1=75KΩ, VCC=12V
VCC=6V, RF=75KΩ,RL=32Ω
2V<VCC<16V, IOUT=-75mA
2V<VCC<16V, IOUT=75mA
Pin 3
Pin 2
f=1KHz, RL=32Ω
VCC=3V, RL=16Ω, THD<10%
VCC=6V, RL=32Ω, THD<10%
VCC=12V, RL=100Ω, THD<10%
VCC=6V, RL=32Ω, POUT=125mW
VCC≥3V, RL=8Ω, POUT=20mW
VCC≥12V, RL=32Ω, POUT=200mW
C1=∞, C2=0.01μF
C1=0.1μF, C2=0, f=1KHz
C1=1μF, C2=5μF, f=1KHz
Mute=2V, 1KHz<f<20KHz
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
1
-30
100
18
80
-0.35
55
250
400
TYP
MAX UNIT
2.7
3.3
65
1.15
2.65
5.65
0
Vcc-1
0.16
-100
150
25
4
5
100
1.25
-200
220
40
0
0.35
0.5
0.5
0.6
1.5
1
50
12
52
70
30
mA
mA
μA
V
V
V
mV
V
V
nA
KΩ
KΩ
dB
dB
mW
mW
mW
%
%
%
MHz
dB
dB
dB
dB
4 of 8
QW-R107-038,H
MC34119
„
LINEAR INTEGRATED CIRCUIT
TYPICAL CIRCUIT
VCC
MUTE
0.001μF
MUTE
VCC
0.01μF
100KΩ
75KΩ
100KΩ
1
6
UTC MC34119
8
4
0.05μF
2
0.05μF
5
3
0.1μF
UTC MC34119
8
4
0.05μF
7
2
7
0.05μF
5.0μF
5.1K
5.1K
5.0μF
5.1K
VCC
VCC
75KΩ
6
Audio Input
3KΩ
1
5
4
0.1μF
UTC MC34119
8
3
2
VEE
-1.0V~-8.0V
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4.7KΩ
SPEAKER
5.1K
SPEAKER
0.1μF
Audio Input
5
3
1
SPEAKER
6
Audio Input
7
20KΩ
MUTE
20KΩ
10KΩ
5 of 8
QW-R107-038,H
MC34119
LINEAR INTEGRATED CIRCUIT
TYPICAL CHARACTERISTICS
„
Distortion Versus Power
(f = 1, 3.0kHz, AVD = 12dB)
Differential Gain Versus Frequency
40
Rf = 150kΩ, Ri = 6.0kΩ
Differential Gain (dB)
32
Rf = 75kΩ, Ri = 3.0kΩ
24
Rf
16
0.1
Input
Ri
+
VO1
#1
VO2
8
VO
#2
Total Harmonic Distortion, THD (%)
10
VCC = 3.0V
RL = 32Ω
8.0
VCC = 3.0V
RL = 16Ω
6.0
4.0
0
0
100
1.0k
0
10k 20k
100
200
400
500
Device Dissipation, 32ΩLoad
Device Dissipation, 16Ω Load
1200
1200
VCC = 16V
Device Dissipation (mW)
1000
800
VCC = 6.0V
600
400
VCC = 3.0V
200
VCC = 12V
VCC = 16V
VCC = 12V
1000
Device Dissipation (mW)
300
Output Power, POUT (mW)
Frequency, f (Hz)
800
600
400
VCC = 6.0V
200
VCC = 3.0V
0
0
0
100
200
300
0
400
100
200
300
Load Power (mW)
Load Power (mW)
Distortion Versus Power
(f = 1.0kHz, AVD = 34dB)
Distortion Versus Power
(f = 3.0kHz, AVD = 34dB)
400
500
10
VCC = 3.0V
RL = 16Ω
8.0
VCC = 3.0V
RL = 32Ω
VCC = 6.0V
RL = 32Ω
6.0
VCC = 6.0V
RL = 16Ω
4.0
VCC = 6.0V
RL = 16Ω
VCC = 12V,16V
RL = 32Ω
VCC =12V, 16V
RL = 16Ω
2.0
THD, Total Harmonic Distortion (%)
10
THD, Total Harmonic Distortion (%)
VCC = 12V,16V
RL = 16Ω,32Ω
VCC = 6.0V
RL = 16Ω,32Ω
2.0
VCC = 3.0V
RL = 16Ω
VCC =6V
RL = 16Ω,32Ω
8.0
VCC = 3.0V
RL = 16Ω
6.0
4.0
VCC =12V,16V
RL = 16Ω,32Ω
2.0
0
0
0
100
200
300
400
500
Output Power, POUT (mW)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
0
100
200
300
400
500
Output Power, POUT (mW)
6 of 8
QW-R107-038,H
MC34119
LINEAR INTEGRATED CIRCUIT
TYPICAL CHARACTERISTICS(Cont.)
Input
80mV/DIV
VCC–VOH(V)
Output
1.0V/DIV
Input
1.0mV/DIV
Output
20mV/DIV
ICC , Power Supply Current (mA)
„
VOL @ VO1, VO2 Versus Load Current
Input Characteristics @ CD (Pin 1)
1.4
200
TA = 25°C
VCC = 3V
Valid for VCD ≤ VCC
160
1.0
0.8
0.6
ICD (μA)
Output Low Level, VOL (V)
1.2
VCC> 6V
120
80
0.4
40
0.2
0
0
40
80
120
160
200
Load Current, ILOAD (mA)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
0.8
0
4.0
8.0
12
16
Chip Disable Voltage, VCD (V)
7 of 8
QW-R107-038,H
MC34119
LINEAR INTEGRATED CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
8 of 8
QW-R107-038,H