Oscilent Corporation IF SAW Filter | 820-IF70.0M-NR Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 820-IF70.0M-NR 20.2 x 12.6 Thru Hole Base Station & Repeater Jan. 01, 2007 . TYPE : 70.0 MHz Bandpass Filter 25.0 MHz Bandwidth PART NUMBER : 820-IF70.0M-NR . FREQUENCY CHARACTERISTICS Horizontal : 5.0 MHz/Div Veritical : 10 dB/Div Horizontal : 3.6 MHz/Div Veritical : 1.0 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.90 70 70.10 MHz Insertion Loss - 26.6 28.0 dB 1dB Bandwidth 24.5 24.9 - MHz 3dB Bandwidth 25.0 25.6 - MHz 40dB Bandwidth - 28.6 30.0 MHz Passband Ripple - 0.74 1.0 dB Group Delay Variation - 45 70 nsec Absolute Delay - 1.64 - µsec Center Frequency Ultimate Rejection 50 55 - dB Substrate Material - LN - - Ambient Temperature - 25 - °C * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 820-IF70.0M-NR Page 2 of 2 L1 = 220nH C1 = 33pF L2 = 270nH C2 = 22pF Source/Load Impedance = 50 ohms Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF70.0M-NR