Product Profile MB86H22 SmartMPEG November 2003 Edition 0.55 MPEG-2 Decoder for ext. Temperature Range INTRODUCTION: FEATURES This SmartMPEG is an integrated MPEG-2 settop-box decoder which includes the hardware extensions required to support a low Bill of Material for Set-TopBoxes and IDTVs. • • • • • • Highlights of the SmartMPEG include an ARC RISC CPU (@130.5MHz), two transport stream demultiplexers with integrated DVB descramblers, a PAL/ NTSC/SECAM digital video encoder and a display controller, which overlays up to four layers of graphic data. A specially designed, shared SDRAM memory interface for the CPU and MPEG decoder connects to a single SDRAM device using either a 16 or 32-bit data bus depending on customer bandwidth requirements. The included universal processor interface allows simple connection to FLASH, hard disk drives (IDE), Common Interface and other asynchronous devices. • • • • • • • • • • • • • • • • • • • • • • To help our customers achieve the shortest possible timeto-market, the SmartMPEG comes with the Fujitsu Driver Application Programming Interface (FAPI). FAPI is a complete driver set, allowing fast and efficient customer software design. In addition, FAPI is now the standard programming interface for Fujitsu DVB components, easing migration to future devices. Shared Memory MPEG2 video ISO/IEC 13818-2 ([email protected]@ML) MPEG audio layer 1/2 32-bit RISC CPU (ARC Tangent A4 @130.5MHz) 4K I-cache, 2K D-cache Three timers / watchdog / power-down mode Shared memory interface (SDRAM, 16/32 bit data), 64Mbit...1Gbit Universal processor interface (IDE, NAND/NOR FLASH & Common Interface) Two transport stream decoders (decoding/recording) including two DVB descrambler Flexible MPEG video resizing (factor 1/16 to 2) Display controller with up to 4 true colour graphic or CLUT layers (total 6 layers) Flexible frame rate conversion (e.g. 50/60Hz) Flicker fixer for better on-screen text clarity Teletext / WSS / VPS / CC / VBID insertion PAL/NTSC/SECAM digital encoder RGB De-matrix (RGB or YCrCb output) Control of brightness, contrast and colour saturation of RGB and YCrCb output 5 video DAC’s @10bit for analogue video / audio O/P ITU-R 656 video input/output (shared with TS2 input) S/P DIF output for PCM/AC3/MPEG UART / 2 x Smart Card IF / I2C / GPIO / PWM Output 7-segment LED controller for 5 digits / KeyBoard mon. Infra Red receiver / transmitter On-chip DPLL, requiring only 27.0MHz crystal Bootable from NOR Flash or I2CPROM FPT-208P-M06 (LQFP-Package) Ambient Temperature Range: -40oC to +85oC Advanced Technology: Fujitsu CMOS Cx81 (0.18µm) 1.8 volt device with 3.3 volt I/O Power consumption: typ. 700mW (Standby: 100mW) • The SmartMPEG is part of Fujitsu’s MPEG decoder family, and is the successor to the MB87L2250. The SmartMPEG offers several advantages over the MB87L2250, including support for 16/32-bit SDRAM devices up to 128Mbytes, an integrated S/P-DIF interface, DPLL, and internal audio DAC’s. This helps to reduce product cost by eliminating the need for external components. The SmartMPEG adds also DPLL functionality, SECAM encoding, and two Smart-card interface to former MPEG devices. S/P-DIF (Dolby Dig. Bitstream) I2S (Audio) SDRAM (64Mbit … 1Gbit) FME/MM/PP/1103 ITU-R656 Analog O/P: CVBS, YC, RGB ITU-R656 YCRCB, Audio R/L 16/32 bit [email protected] Tangent-A4 4K I-Cache 2K D-Cache WatchDog PowerDown IRQ CTRL 3 Timers Shared Memory Interface MPEG-2 Video Decoder MPEG Audio Decoder S/P-DIF Output Unit Resizing TXT Insertion Display Controller (2 x 2 Layer) Digital Encoder (PAL/NTSC/ SECAM) WSS / VPS Insertion CC/VBID Insertion Adjustable RGB De-Matrix DAC1 DAC2 DAC3 DAC4 DAC5 ITU-R656 Output SmartMPEG Internal Bus @ 130.5MHz DPLL Buffer Mgr DVB Descramblers TS3 intern TS Demultiplexers TS1 TS2 Par/Ser Par/Ser 27.0MHz HDD/IDE CTRL Boot ROM Chip Select CTRL Universal Processor Interface NOR / NAND Flash HDD / IDE / CI Copyright © 2003 Fujitsu Microelectronics Europe GmbH IR Rx IR Tx GPIO GPI GPO I2C UART 2 Smart Card PWM 7-Seg CTRL IRQ / I2C / 2 Smart Card UART / IR In / IR Out GPIO / 7-Segment Ctrl PWM / KeyBoard Mon Preliminary Page 1 of 2 Disclaimer: The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU sales representatives before ordering.The information and circuit diagrams in this document are presented “as is”, no license is granted by implication or otherwise. SmartMPEG November 2003 Edition 0.55 FME/MM/DM/1103 MB86H22 MPEG-2 Decoder for ext. Temperature Range Worldwide Headquarters Japan Tel: +81 3 5322 3353 Fax: +81 3 5322 3386 Asia Fujitsu Limited Marketing Division Electronic Devices Shinjuku Dai-Ichi Seimei Bldg.7-1 Nishishinjuku 2-chome, Shinjuku-ku Tokyo 163-0721 Japan http://edevice.fujitsu.com/ Tel: +65 6281 0770 Fax: +65 6281 0220 Fujitsu Microelectronics Korea Ltd. 1702 Kosmo Tower, 1002 Daechi-Dong Kangnam-Gu, Seoul 135-280, Korea http://www.fmal.fujitsu.com/ http://www.fmk.fujitsu.com/ Tel: +82 2 3484 7100 Fax: +82 2 3484 7111 USA Europe Fujitsu Microelectronics America, Inc. 3545 North First Street San Jose, CA 95134-1804 USA Tel: +1 800 866 8608 Customer Response Center Fax: +1 408 922 9179 Mon-Fri: 7am-5pm (PST) http://www.fma.fujitsu.com/ Tel: +49 6103 690-0 Fax: +49 6103 690122 Tel: +1 408 922 9000 Fax: +1 408 922 9179 Fujitsu Microelectronics Asia PTE Limited #05-08, 151 Lorong Chuan New Tech Park, Singapore 556741 e-mail Fujitsu Microelectronics Europe GmbH Am Siebenstein 6-10 D-63303 Dreieich-Buchschlag Germany [email protected] http://www.fme.fujitsu.com/ All Rights Reserved. The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU sales representatives before ordering. The information and circuit diagrams in this document are presented as examples of semiconductor device applications, and are not intended to be incorporated in devices for actual use. Also, FUJITSU is unable to assume responsibility for infringement of any patent rights or other rights of third parties arising from the use of this information or circuit diagrams. The products described in this document are designed, developed and manufactured as contemplated for general use, including without limitation, ordinary industrial use, general office use, personal use, and household use, but are not designed, developed and manufactured as contemplated (1) for use accompanying fatal risks or dangers that, unless extremely high safety is secured, could have a serious effect to the public, and could lead directly to death, personal injury, severe physical damage or other loss (i.e., nuclear reaction control in nuclear facility, aircraft flight control, air traffic control, mass transport control, medical life support system, missile launch control in weapon system), or (2) for use requiring extremely high reliability (i.e., submersible repeater and artificial satellite). Please note that Fujitsu will not be liable against you and/or any third party for any claims or damages arising in connection with above-mentioned uses of the products. Any semiconductor devices have an inherent chance of failure. You must protect against injury, damage or loss from such failures by incorporating safety design measures into your facility and equipment such as redundancy, fire protection, and prevention of over-current levels and other abnormal operating conditions. If any products described in this document represent goods or technologies subject to certain restrictions on export under the Foreign Exchange and Foreign Trade Control Law of Japan, the prior authorization by Japanese government will be required for export of those products from Japan. Use of this product in any manner that complies with the MPEG-2 Standard is only permitted with a license under applicable patents in the MPEG-2 patent portfolio, which is available from MPEG LA, LLC, 250 Stelle Street, Suite 300, Denver, Colorado 80206, URL: www.mpegla.com. 3 Copyright © 2003 Fujitsu Microelectronics Europe GmbH Preliminary Page 2 of 2 Disclaimer: The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU sales representatives before