DC COMMON MODE CHOKE COIL <SMD Type: CLP Series> Type: CLP82 ◆ Product Description ・9.0×9.7mm Max.(L×W), 2.5mm Max. Height . ◆ Feature ・One common mode choke or pulse transformer is stored in it. ・Ideally used in PCMCIA card. ・RoHS Compliance ◆ Dimensions (mm) MAX.2.5 9 .4 ±0. 3 6 .5 0.5 0.25 MA X.9. 0 1.27 2.54 ＊ Pin pitch shall be measured at the root of terminal. ＊ Dimension does not include solder used on coil. ◆ Land Pattern (mm) ◆ Schematics (Bottom) 10.2 1.27 1.27 1.27 1.27 1.27 1.0 1.0 1.0 1.0 1.0 1.0 5.5 ⑥ ⑦ ⑤ ⑧ ④ ⑨ ③ ⑩ ② ⑪ ① ⑫ Mark “・” is Polarity Please refer to the sales offices on our website for a representative near you www.sumida.com 1/2 DC COMMON MODE CHOKE COIL <SMD Type: CLP Series> Type: CLP82 ◆ Specification Between (1-3), (4-6), (7-9), (10-12) Measuring Conditions １.Sine Wave Inductance 400µH(REF.) 100kHz, 20mVrms ２. Interwinding Capacity MAX.10.0pF 100kHz, 20mVrms ３.Leakage Inductance MAX.2.5µH 100kHz, 20mVrms 4.D.C.R. MAX.0.7Ω at 20℃ AC 1500Vrms ５.Ｈi-Pot for 1 minute 50Hz or 60Hz ※LEAKAGE INDUCTANCE MEASURING (10-12) to be short connected when the leakage inductance(1-3) is measured. (7-9) to be short connected when the leakage inductance(4-6) is measured. (4-6) to be short connected when the leakage inductance(7-9) is measured. (1-3) to be short connected when the leakage inductance(10-12) is measured. Please refer to the sales offices on our website for a representative near you www.sumida.com 2/2