TS4558 Dual General Purpose Operational Amplifier SOP-8 DIP-8 Pin Definition: 1. Output A 2. Input A (-) 3. Input A (+) 4. Ground 8. Vcc 7. Output B 6. Input B (-) 5. Input B (+) General Description The TS4558 is dual general purpose operational amplifier, and provide the high common-mode input voltage range and the absence of latch-up make these amplifiers ideal for voltage follower application. The devices are short circuit protected and the internal frequency compensation ensures stability without external components. The TS4558 is offered in 8 pin SOP-8 and DIP-8 package. Features ● ● ● ● ● ● ● Block Diagram Short circuit protection Wide common-mode and differential ranges No frequency compensation required Low power consumption No latch-up 3MHz unity gain bandwidth guaranteed Gain and phase match between amplifiers Applications ● ● DVD player Audio application Ordering Information Part No. TS4558CD C3 TS4558CS RL Package Packing DIP-8 SOP-8 50pcs / Tube 2.5Kpcs / 13” Reel Schematic (each amplifier) 1/7 Version: A07 TS4558 Dual General Purpose Operational Amplifier Absolute Maximum Rating Parameter Symbol Supply Voltage Supply Voltage Differential Input Voltage Input Voltage Value Unit Vcc + Vcc VIDR Vin 18 V -18 V ±30 V 30 V DIP-8 97 Package Thermal Impedance θja °C/W SOP-8 85 Operating Junction Temperature Range TJ 0 ~ +70 °C Storage Temperature Range TSTG -65 ~ +150 °C Lead Temperature 1.6mm(1/16”) from case for 10Sec. TLEAD 260 °C Note: Maximum ratings are those values beyond which damage to the device may occur, and functional operation should be restricted to the recommended operating condition. Recommended Operating Conditions Parameter Supply Voltage Supply Voltage Symbol Value Unit Vcc + Vcc - 15 -15 V V Electrical Specifications (VCC = ±15V, Ta =25oC; unless otherwise noted) Parameter Input Offset Current Input Bias Current Input Resistance Unity Gain Bandwidth Large-Signal Voltage Gain Output Voltage Swing Input Common-Mode Voltage Range Common-Mode Rejection Ratio Supply Voltage Rejection Ratio Slew Rate Symbol Iio Iib Ri B1 Av Vom Test Conditions RL ≥ 2kΩ, Vc = ±10V RL ≥ 10kΩ RL ≥ 2kΩ Vicr CMRR PSRR SR Rs ≤ 10kΩ Rs ≤ 10kΩ RL = 2kΩ, Vin=10V, L=100pF Min Typ Max Unit --0.3 -20 ±12 ±10 20 150 5 3 300 ±14 ±14 ±200 500 ------ nA nA MΩ MHz V/mV ±12 ±13 -- V 70 -- 90 30 -150 dB uV/V 0.8 1.6 -- V/uS V Supply Current I+, I -2.5 5.6 mA Power Consumption Pc RL = ∞ -75 170 mV Input Noise Voltage Vn Rs = 1kΩ, f = 30Hz~30KHz --3.5 uVrms Source Current Isource -20 --mA Sink Current Isink 20 --mA Note : All characteristics are measured under open-loop conditions with zero common-mode input voltage, unless otherwise specified. 2/7 Version: A07 TS4558 Dual General Purpose Operational Amplifier Electrical Characteristics Curve Figure 1. Burst Noise vs. Source Resistance Figure 2. RMS Noise vs. Source Resistance Figure 3. Output Noise vs. Source Resistance Figure 4. Spectral Noise Density Figure 5. Burst Noise Test Citcuit 3/7 Version: A07 TS4558 Dual General Purpose Operational Amplifier Electrical Characteristics Curve Figure 6. Open Loop Frequency Response Figure 7. Phase Margin vs. Frequency Figure 8. Positive Vout Swing vs. Load Resistance Figure 9. Negative Vout Swing vs. Load Resistance Figure 11. Transient Response Test Circuit Figure 10. Power Bandwidth (Large Signal Swing vs. Frequency) 4/7 Version: A07 TS4558 Dual General Purpose Operational Amplifier SOP-8 Mechanical Drawing DIM A B C D F G K M P R 5/7 SOP-8 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX. 4.80 5.00 0.189 0.196 3.80 4.00 0.150 0.157 1.35 1.75 0.054 0.068 0.35 0.49 0.014 0.019 0.40 1.25 0.016 0.049 1.27BSC 0.05BSC 0.10 0.25 0.004 0.009 0º 7º 0º 7º 5.80 6.20 0.229 0.244 0.25 0.50 0.010 0.019 Version: A07 TS4558 Dual General Purpose Operational Amplifier DIP-8 Mechanical Drawing DIM A B C D G J K L M 6/7 DIP-8 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 9.07 9.32 0.357 0.367 6.22 6.48 0.245 0.255 3.18 4.45 0.125 0.135 0.35 0.55 0.019 0.020 2.54 (typ) 0.10 (typ) 0.29 0.31 0.011 0.012 3.25 3.35 0.128 0.132 7.75 8.00 0.305 0.315 o o 10 10 Version: A07 TS4558 Dual General Purpose Operational Amplifier Notice Specifications of the products displayed herein are subject to change without notice. TSC or anyone on its behalf, assumes no responsibility or liability for any errors or inaccuracies. Information contained herein is intended to provide a product description only. No license, express or implied, to any intellectual property rights is granted by this document. Except as provided in TSC’s terms and conditions of sale for such products, TSC assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sale and/or use of TSC products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright, or other intellectual property right. The products shown herein are not designed for use in medical, life-saving, or life-sustaining applications. Customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify TSC for any damages resulting from such improper use or sale. 7/7 Version: A07