UNISONIC TECHNOLOGIES CO., LTD 3512 CMOS IC PC POWER SUPPLY SUPERVISORS DESCRIPTION DIP-14 The UTC 3512 is specially designed for switching power supply system. It provides over-voltage protection, over-current protection, under-voltage protection, on/off control and power good signal generating. OVP/UVP (Over/Under-Voltage Protection) monitors 3.3V, 5V and double 12V to protect our power supply and PC, FPO goes to high when one of these supply voltages exceeds their normal operation voltage range. OCP (Over Current Protection) monitors IS33, IS5, IS12 input current. The voltage difference across external current shunt is used for OCP functions. An external resistor which is connected between the RI pin and the GND pin can be used to adjust protection threshold. To achieve better immunity for lighting surge glitch and to prevent accidental power shut down during dynamic loading condition, the de-bounce time for UVP/OCP is 73us respectively. The deglitch time for OVP is 73uS for better noise immunity. The power supply is turned on after 38mS de-bounce time when PSON signal is set from high to low. To turn off power supply, PSON signal is set from low to high and the de-bounce time is 115mS. When PGI input voltage level is lower than the internal 1.15V reference voltage, after 73uS de-bounce time, the PGO signal is pulled low. SOP-14 *Pb-free plating product number: 3512L FEATURES * Over/Under-voltage protection for 3.3V, 5V, and two 12V * Over-current protection for 3.3V, 5V, and two 12V * PGO and FPO pins with open drain output stage * 300mS power good delay from PGI to PGO * 75mS delay for 3.3V, 5V and 12V power turn on * 2.8mS delay for PSON control to FPO turn off * 38mS / 115mS PSON on/off de-bounce time * 73uS width noise deglitches * 73uS de-bounce time for UVP and OCP * Wide supply voltage range ORDERING INFORMATION Normal 3512-D14-T 3512-S14-R 3512-S14-T Order Number Lead Free Plating 3512L-D14-T 3512L-S14-R 3512L-S14-T www.unisonic.com.tw Copyright © 2005 Unisonic Technologies Co., Ltd Package Packing DIP-14 SOP-14 SOP-14 Tube Tape Reel Tube 1 of 9 QW-R502-073,A 3512 CMOS IC ORDERING INFORMATION(Cont.) 3512L-D14-T (1)Packing Type (2)Package Type (3)Lead Plating UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw (1) R: Tape Reel, T: Tube (2) D14: DIP-14, S14: SOP-14 (3) L: Lead Free Plating, Blank: Pb/Sn 2 of 9 QW-R502-073,A 3512 CMOS IC PIN CONFIGURATION PGI 1 14 PGO GND 2 13 VDD FPO 3 12 VS5 PSON 4 11 VS33 IS12 5 10 V S12 RI 6 9 IS33 V S12B 7 8 IS5 PIN DESCRIPTION PIN NO 1 3 PIN NAME PGI FPO TYPE input output 4 PSON input 8 9 IS5 IS33 input input 5 IS12 input 6 RI input 12 7 10 11 13 VS5 VS12B VS12 VS33 VDD input input input input power 14 PGO output 2 GND power DESCRIPTION Power good input. Fault protection output, open drain output stage. Power on/off control signal sends from CPU or main-board. The power supply will be turned on/off after 38mS/115mS respectively. 5V over current protection. 3.3V over current protection. 12V over current protection. Regarding typical application, this pin is connected to the positive end of a current shunt through one resistor. When the voltage on IS12 is higher than that of VS12 by 5mV, OCP will be enabled. One current sink, 8 x IREF, is used to determine the voltage drop between the positive end of the current shunt and VS12. Adjusting the value of the external resistor can adjust the threshold for OCP accordingly. The operation for IS5 or IS33 is the same. Current sense setting. An external resistor Ri is connected between RI pin and GND pin will adjust a reference current, IREF = 1.15/Ri, for OCP function. 5V over/under-voltage protection. Second 12V over/under-voltage protection. 12V over/under-voltage protection. 3.3V over/under-voltage protection. Supply voltage. 4V ~ 15V. Power good logic output, open drain output stage. The power good delay is 300mS from PGI to PGO. Ground. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 9 QW-R502-073,A 3512 CMOS IC BLOCK DIAGRAM PWR Power On Reset 2.4 ms Clr delay 38ms /115ms debounce PSON RST UN + VS33 PWR Clr Bandgap Reference 75ms delay VREF=1.15 V OV + UN + VS 5 OV + UN + VS12A OV + RST UN + VS12 B 73µs debounce OV + FPO R S Q RST VREF PGI IS33 IS 5 UN + V12A + I REF×8 V12A + I REF×8 V12A IS12 73µs debounce VREF=1.15 V clr PGO 300ms delay + - I REF=VREF/RI RI + V12A + IREF×8 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 9 QW-R502-073,A 3512 CMOS IC ABSOLUTE MAXIMUM RATING PARAMETER SYMBOL VDD VIN RATINGS UNIT -0.3 ~ 16 V PSON, VS33, VS5, PGI -0.3 ~ 8 V FPO -0.3 ~ 16 Output Voltage VOUT V PGO -0.3 ~ 8 Power Dissipation PD 400 mW Operating Temperature TOPR -40 ~ +85 ℃ Storage Temperature TSTG -55 ~ +150 ℃ Note 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. Stresses above those listed may cause permanent damage to the device. DC Supply Voltage Input Voltage RECOMMENDED OPERATING CONDITIONS PARAMETER DC Supply Voltage Input Voltage Input Voltage Output Voltage Output Sink Current SYMBOL VDD PSON, VS33, VS5, IS33, IS5, PGI VS12,VS12B, IS12 FPO PGO FPO PGO See Note MIN 4 VIN VOUT IO(SINK) Supply Voltage Rising Time Output Current RI Note VDD rising and falling slew rate must be less than 14V/mS. tR IRI MAX 15 7 15 15 7 20 10 1 12.5 UNIT V V V mA mS µA 62.5 ELECTRICAL CHARACTERISTICS (VDD=12V, TA=25℃) PARAMETER SYMBOL UNDER-VOLTAGE AND PGI, PGO Input Threshold Voltage PGI VPGI Under-voltage protect VS33 VUVp Under-voltage protect VS5 Under-voltage protect VS12, VS12B Low Level Output Voltage (PGO) VOL Leakage Current (PGO) ILEAK Under-voltage Enable Delay Time Timing PG Delay PGI to PGO tPG Noise Deglitch Time PGI to PGO Timing UVP to Protection (FPO) TUVP OVER-VOLTAGE AND OVER-CURRENT PROTECTION Over-Voltage Protection VS33 VOVP Over-Voltage Protection VS5 Over-Voltage Protection VS12, VS12B Ratio of Current Sense Sink Current to Current IREF Sense Setting Pin (RI) Source Current Current Source Reference Voltage VREF OCP Comparator Input Offset Voltage VI(OFF) Low Level Output Voltage (FPO) VOL Leakage Current (FPO) ILEAK Timing OVP to Protection TOVP Timing OCP to Protection TOCP UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS MIN TYP MAX UNIT 1.1 2.6 4.0 9.4 1.15 2.8 4.2 9.9 1.2 3.0 4.4 10.4 0.7 5 114 450 350 V VDD = 12V ISINK =10mA PGO = 5V 49 200 150 75 300 250 73 3.7 5.7 13.2 3.9 6.1 13.8 4.1 6.5 14.4 7.6 8 8.4 1.1 -5 1.15 1.2 5 0.7 5 VS33,VS5, VS12,VS12B RI = 30 ΚΩ, 0.1% Resistor ISINK =20mA V(FPO) = 5V 73 73 V V µA mS mS µS µS V V mV V µA µS µS 5 of 9 QW-R502-073,A 3512 CMOS IC ELECTRICAL CHARACTERISTICS(Cont.) PARAMETER PSON CONTROL High-Level Input Voltage Low-Level Input Voltage Timing PGO Low to FPO High Timing PSON to On/Off SYMBOL ON OFF Input Pull-up Current TOTAL DEVICE Supply Current VDD Start Threshold Voltage VDD Min. Operation Voltage After Start-up MIN VIH VIL 1.9 TPSOFF 1.6 24 24 TYP IPSON PSON = 0V 2.8 38 38 120 IDD VTHD VMIN PSON = 5V, VDD = 5V 1.0 TPSON UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS 3.65 MAX UNIT 0.98 4.0 57 57 V V mS mS mS µA 1.8 4.0 mA V V 6 of 9 QW-R502-073,A 3512 CMOS IC TYPICAL APPLICATION CIRCUIT Power Supply Output Side 12V 12V 12V 12V 5V PGI PSON UTC 3512 1 PGI 2 GND 3 FPO 4 PSON 5 I 6 S12 RI 7 VS12B PGO V DD VS5 V S33 V S12 IS33 IS5 14 13 12 11 10 9 8 5V VSB 3.3V System Side UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 7 of 9 QW-R502-073,A 3512 CMOS IC TIMING DIAGRAM PSON On/Off and 3.3V, 5V,12V OVP Function VDD PSON TPSON(ON) TPSON(OFF) FPO T OVP PGI T PSOFF TPG PGO 3.3V,5V,12V 3.3V,5 V,12V OVP UVP and OCP Function VDD PSON FPO PGI TOVP T UVP PGO 12V OCP TOCP UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 8 of 9 QW-R502-073,A 3512 CMOS IC UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 9 of 9 QW-R502-073,A