STEVAL-CCA011V1 Filter-free stereo 2x2.5 W Class-D audio power amplifier demonstration board based on the TS2012FC Data brief Features ■ Operating range from VCC = 2.5 V to 5.5 V ■ Dedicated standby mode active low for each channel ■ Output power per channel: 1.15 W @5 V or 0.63 W @ 3.6 V into 8 Ω with 1% THD+N max ■ Output power per channel: 1.85 W @5 V into 4 Ω with 1% THD+N max ■ Output short-circuit protection ■ Four gain select settings: 6, 12, 18, 24 dB ■ Low current consumption ■ PSRR: 63 dB typ @ 217 Hz with 6 dB gain ■ Fast start-up phase: 8 ms ■ Thermal shutdown protection ■ RoHS compliant STEVAL-CCA011V1 Description This demonstration board is based on TS2012FC that is a fully differential Class-D stereo power amplifier able to drive up to 1.15 W into an 8 Ω load at 5 V per channel. It achieves better efficiency compared to typical Class-AB audio amps. The device has four different gain settings that use two digital pins: G0 and G1. Pop and click reduction circuitry provides low on/off switch noise while allowing the device to start within 8 ms. Two standby pins (active low) allow each channel to be switched off independently. The TS2012FC also integrates output shortcircuit protection and thermal shutdown protection and it is available in a 16-bumps Flip-Chip package. June 2009 Doc ID 15789 Rev 1 For further information contact your local STMicroelectronics sales office. 1/6 www.st.com 6 Circuit schematics STEVAL-CCA011V1 Circuit schematics Figure 1. Schematic diagram GND LinLin+ GND 1 Vcc Vcc P1 4 3 2 1 100nF C5 Vcc 1 2 1 2 JP1 JP5 C6 1uF U1 A2 Vcc 220nF C2 D2 Vcc C1 AVCC PVCC JP3 220nF LinP A1 Lin+ B1 Lin- G0 C2 G0 G1 B2 G1 D1 Rin+ 3 S1 A3 Lout- A4 PWM Select Bridge 1 2 LinN Lout+ H Gain Header 4 2 JP6 1 VCC 1 2 3 4 G0 Oscillator 3 S2 2 JP7 1 VCC JP4 RinP 1 2 G1 RinN C1 Rin- B4 STBYL STBR B3 STBYR Rout+ D3 Rout- D4 H Gain PWM Select Bridge C3 1 2 3 4 Header 4 Standby Control C3 TS2012 - FC16 GND Rin+ RinGND VCC PGND 1 3 1 3 S4 STBR Pgnd JP2 1 2 3 4 1 2 S3 STBL JP8 Table 1. VCC Component list for the demonstration board Designation 2/6 AGND 2 2 220nF Protection Circuit C4 STBL 220nF C4 Quantity Description C1, C2, C3, C4 4 220 nF/16 V, SMD ceramic capacitor, 0603 C5 1 100 nF/16 V, SMD ceramic capacitor, 0603 C6 1 1 µF/16 V, SMD ceramic capacitor, 0603 P1, JP5, JP6, JP7, JP8 5 2-pin header 2.54 mm pitch S1, S2, S3, S4 4 3-pin header 2.54 mm pitch JP1, JP2, JP3, JP4 4 4-pin header 2.54 mm pitch U1 1 TS2012EIJT Doc ID 15789 Rev 1 STEVAL-CCA011V1 2 Demonstration board layout Demonstration board layout The following figures depict the top view and layers of the demonstration board. Figure 2. PCB top layer Figure 3. PCB middle layer 1 Figure 4. PCB middle layer 2 Figure 5. PCB bottom layer Doc ID 15789 Rev 1 3/6 Demonstration board layout Figure 6. 4/6 STEVAL-CCA011V1 Top view and dimensions of the demonstration board Doc ID 15789 Rev 1 STEVAL-CCA011V1 3 Revision history Revision history Table 2. Document revision history Date Revision 03-Jun-2009 1 Changes Initial release. Doc ID 15789 Rev 1 5/6 STEVAL-CCA011V1 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2009 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 6/6 Doc ID 15789 Rev 1