S4558 F Semiconductor Low Noise Dual OP AMP Description The S4558 is a monolithic Integrated Circuit designed for dual operational amplifier. Features • • • • • • Power consumption as small as about 50mW (typ.) Built-in output short-circuit protecting circuit. Internal phase consumption type. No latch-up Wide same phase mode and differential voltage ranges High gain. low noise Applications • • • • Active filters Audio amplifiers VCOs Other electronic circuits Ordering Information Type NO. S4558 Marking Package Code S4558 SOP-8 Outline Dimensions unit : mm Block Diagram KSI-8002-001 1 S4558 Absolute maximum ratings Characteristic Symbol Ratings Unit Supply voltage VCC 36 or ±18 V Differential input voltage VIND 30 V Input voltage VIN ±15 V Power Dissipation PD 300 mW Operating temperature Topr -45 ~ +85 °C Storage temperature Tstg -55 ~ +150 °C Electrical Characteristics (Unless otherwise specified. VCC = +15V, VEE=-15V and Ta = 25 °C) Characteristic Symbol Input offset voltage VIOS Input offset current IIOS Input bias current Test Condition Rg ≤ 10 ㏀ Min. Typ. Max. Unit - 0.5 6 mV - - 5 200 nA IIB - - 60 500 nA Input common mode Voltage Range VICR - ±12 ±14 - V ±14 VOM RL≥ 10 ㏀ ±12 Maximum Output Voltage - V RL≥ 2 ㏀ ±10 ±13 - V Vout=±10V, RL≥ 2 ㏀ 86 100 - dB Large signal Voltage Gain GV Common mode rejection ratio CMRR Rg ≤ 10 ㏀ 70 90 - dB Power supply rejection ratio PSRR Rg ≤ 10 ㏀ - 30 150 uV/V GV=1, RL≥ 2 ㏀ - 1.0 - V/us - 4.0 6.0 mA - 2.5 - uVrms Slew Rate SR Supply Current ICC Equivalent input noise voltage VNI Source Current Sink Current RIAA, RS=1 ㏀, f=30 ㎐~30 ㎑ ISOURCE - 27 - - mA ISINK - 27 - - mA KSI-8002-001 2 S4558 Electrical Characteristic Curves Fig. 1 GV - f Fig. 3 IIB - Ta Fig. 5 VOP-P - RL Fig. 2 VOP-P - f Fig. 4 VOM - VCC, VEE Fig. 6 VNI - f KSI-8002-001 3 S4558 These AUK products are intended for usage in general electronic equipments(Office and communication equipment, measuring equipment, domestic electrification, etc.). Please make sure that you consult with us before you use these AUK products in equipments which require high quality and/or reliability, and in equipments which could have major impact to the welfare of human life(atomic energy control, airplane, spaceship, traffic signal, combustion central, all types of safety device, etc.). AUK cannot accept liability to any damage which may occur in case these AUK products were used in the mentioned equipments without prior consultation with AUK. KSI-8002-001 4