R1200 THRU R2000 HIGH VOLTAGE SILICON RECTIFIER Reverse Voltage - 1200 to 2000 Volts Forward Current - 0.2 to 0.5 Ampere Features Low cost Low leakage Low forward voltage drop High current capability Mechanical Data DIM ENSIONS Case: Molded plastic Epoxy: UL94V-0 rate flame retardant Lead: MIL-STD-202 method 208C guaranteed Mounting Position: Any Weight: 0.012 ounce, 0.335 gram inches DIM mm Min. Max. Min. Max. A 0.165 0.205 4.2 5.2 B 0.079 0.106 2.0 2.7 C 0.028 0.034 0.71 0.86 D 1.000 - 25.40 - Maximum Ratings and Electrical Characteristics Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols R1200 R1500 R1800 R2000 Units Maximum repetitive peak reverse voltage VRRM 1200 1500 1800 2000 Volts Maximum RMS voltage VRMS 840 1050 1260 1400 Volts Maximum DC blocking voltage VDC 1200 1500 1800 2000 Volts Maximum average forward rectified current 0.375" (9.5mm) lead length at TA=50 I(AV) 200 mAmps Peak forward surge current 8.3mS single half sine-wave superimposed on rated load (MIL-STD-750D 4066 method) IFSM Maximum instantaneous forward voltage at 0.5/0.2A DC VF Maximum full load reverse current average, full cycle 0.375" (9.5mm) lead length at TL=75 Maximum DC reverse current at rated DC blocking voltage TA=25 TA=100 Typical junction capacitance (Note 1) Operating and storage temperature range 500 30.0 2.0 Amps 3.0 Volts IR(AV) 30.0 A IR 5.0 50.0 A CJ 30.0 F TJ, TSTG -65 to +175 Note: (1) Measured at 1.0MHz and applied reverse voltage of 4.0 volts 1 Note RATINGS AND CHARACTERISTIC CURVES 2