1F10 thru 1F18 High Voltage Fast Recovery Rectifiers Reverse Voltage 1000 to 1800 Volts Forward Current 1.0 Ampere Features Fast switching Low leakage Low forward voltage drop High current capability High currenf surge High reliability Mechanical Data Case: Molded plastic R-1 Epoxy: UL 94V-O rate flame retardant Lead: MIL-STD-202E method 208C guaranteed Mounting position: Any Weight: 0.007 ounce, 0.20 gram Maximum Ratings and Electrical Characteristics Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Parameter Symbols 1F 10 1F 12 1F 14 1F 15 1F 16 1F 18 Units Maximum repetitive peak reverse voltage VRRM 1000 1200 1400 1500 1600 1800 Volts Maximum RMS voltage VRMS 700 840 980 1050 1120 1260 Volts 1000 1200 1400 1500 1600 1800 Volts Maximum DC blocking voltage V DC Maximum average forward rectified current at TA=50oC IF(AV) 0.5 Amp Peak forward surge current, 8.3 ms single half sinewave superimposed on rated load (JEDEC Method) IFSM 25.0 Amps Maximum instantaneous forward voltage at 0.5A DC VF 1.8 Volts Maximum DC reverse current at rated DC blocking voltage at TA=25oC IR 5.0 uA IR(AV) 100 uA trr 300 ns CJ 15 pF TJ, TSTG -55 to +150 Maximum full load reverse current average, full cycle average, .375" (9.5mm) lead length at TL=55oC Maximum reverse recovery time (Note 1) Typical junction capacitance (Note 2) Operating junction and storage temperature range Notes: 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A 2. Measured at 1 MHZ and applied reverse voltage of 4.0 volts 737 o C RATINGS AND CHARACTERISTIC CURVES (TA = 25oC unless otherwise noted) 738