RL151 thru RL157 General Purpose Plastic Rectifiers Reverse Voltage 50 to 1000 Volts Forward Current 1.5 Amperes Features Low cost Low leakage Low forward voltage drop High current capability TJ is 150oC (Max.) and TSTG is 175oC (Max.) with PI glue Mechanical Data Case : JEDEC DO-204AC (DO-15) molded plastic Epoxy: UL 94V-O rate flame retardant Lead: MIL-STD-202E method 208C guaranteed Mounting position: Any Weight: 0.014 ounce, 0.39 gram Maximum Ratings and Electrical Characteristics Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20% Parameter Symbols R L 151 R L 152 R L 153 R L 154 R L 155 R L 156 R L 157 Units Maximum repetitive peak reverse voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC blocking voltage V DC 50 100 200 400 600 800 1000 Volts Maximum average forward rectified current at TA=50oC I(AV) 1.5 Amps Peak forward surge current 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 60.0 Amps Maximum instantaneous forward voltage at 1.5A DC VF 1.1 Volts IR 5.0 50 uA IR(AV) 30 uA CJ 20 Maximum DC reverse current at rated DC blocking voltage @TA=25oC @TA=100oC Maximum full load reverse current full cycle average, .375" (9.5mm) lead length at TL=75oC Typical junction capacitance (Note 1) Typical thermal resistance Operating junction temperature range Storage temperature range Notes: pF o RθJA 50 TJ -55 to +125 o C -55 to +150 o C TSTG 1. Measured at 1 MHz and applied reverse voltage of 4.0 volts 55 C/W RATINGS AND CHARACTERISTIC CURVES 56