SNOA THRU SNOM SURFACE MOUNT GENERAL PURPOSE PLASTIC RECTIFIER Reverse Voltage - 50 to 1000 Volts Forward Current - 1.5 Amperes Features For surface mounted applications High temperature metallurgically bonded-no compression contacts as found in other diode-constructed rectifiers Built-in strain relief Easy pick and place Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Complete device submersible temperature of for 10 seconds in solder bath 260 Mechanical Data D IM E N S IO N S in c h e s D IM Case: SMA molded plastic Terminals: Solder plated solderable per MIL-STD-750, method 2026 Polarity: Indicated by cathode band Weight: 0.004 ounce, 0.115 gram A m m M in . M a x . M in . M a x . 0 .2 1 6 0 .2 2 6 5 .4 8 5 .7 4 B 0 .1 7 6 0 .1 8 2 4 .4 8 4 .6 3 C 0 .0 9 4 0 .1 0 0 2 .4 0 2 .5 5 D 0 .1 7 0 0 .1 7 6 4 .3 3 4 .4 8 E 0 .0 3 9 0 .0 5 5 1 .0 0 1 .4 0 F 0 .0 8 0 0 .0 8 1 2 .0 3 2 .0 7 G 0 .0 6 8 0 .0 8 3 1 .7 2 2 .1 0 H 0 .1 1 2 0 .1 1 8 2 .8 5 3 .0 0 J 0 .0 5 7 - 1 .4 4 - K - 0 .0 1 8 - 0 .4 5 L 0 .0 1 6 - 0 .4 0 N o te - M 0 .1 0 9 0 .1 1 5 2 .7 7 2 .9 3 N 0 .1 0 5 0 .1 0 7 2 .6 7 2 .7 3 P 0 .0 7 8 0 .0 8 1 2 .0 0 2 .0 5 Maximum Ratings and Electrical Characteristics Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols SNOA SNOB Maximum repetitive peak reverse voltage VRRM 50 100 200 300 400 500 Maximum RMS voltage VRMS 35 70 140 210 280 350 Maximum DC blocking voltage VDC 50 100 200 300 400 500 600 Maximum average forward rectified current at TL=110 I(AV) 1.5 Amps Peak forward surge current 8.3mS single half sine-wave superimposed on rated load (MIL-STD-750D 4066 method) IFSM 60.0 Amps Maximum instantaneous forward voltage at 1.5A VF 1.10 Volts IR 5.0 200.0 A S Maximum DC reverse current at rated DC blocking voltage TA=25 TA=125 SNOD SNOE SNOG SNOH SNOJ SNOK SNOM Units 600 800 1000 Volts 420 560 700 Volts 800 1000 Volts Maximum reverse recovery time (Note 1) Trr 2.0 Typical junction capacitance (Note 2) CJ 30.0 F 16.0 /W Maximum thermal resistance (Note 3) Operating and storage temperature range R JL TJ, TSTG -55 to +150 Notes: (1) Reverse recovery test conditions: IF=0.5A, IR=1.0A, Irr=0.25A (2) Measured at 1.0MHz and applied Vr=4.0 volts (3) 8.0mm2 (0.013mm thick) land areas 1 RATINGS AND CHARACTERISTIC CURVES 2