S1A THRU S1M SURFACE MOUNT RECTIFIER VOLTAGE - 50 to 1000 Volts CURRENT - 1.0 Ampere FEATURES SMA/DO-214AA l For surface mounted applications l High temperature metallurgically bonded-no compression contacts as found in other diode-constructed rectifiers l Glass passivated junction l Built-in strain relief l Easy pick and place l Plastic package has Underwriters Laboratory Flammability Classification 94V-O l Complete device submersible temperature of 260for 10 seconds in solder bath MECHANICAL DATA Case: JEDEC DO-214AA molded plastic Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 Polarity: Indicated by cathode band Standard packaging: 12mm tape (EIA-481) Weight: 0.003 ounce, 0.093 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current, at TL=100 Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load(JEDEC method) Maximum Instantaneous Forward Voltage at 1.0A Maximum DC Reverse Current TA=25 At Rated DC Blocking Voltage TA=125 Maximum Reverse Recovery Time (Note 1) Typical Junction capacitance (Note 2) Typical Thermal Resistance (Note 3) Operating and Storage Temperature Range SYMBOLS S1A S1B S1D S1G S1J S1K S1M VRRM VRMS VDC I(AV) 50 35 50 100 70 100 200 140 200 400 280 400 1.0 600 420 600 800 560 800 1000 700 1000 UNITS Volts Volts Volts Amps IFSM 30.0 Amps VF IR 1.10 5.0 50 2.5 12 30.0 -55 to +150 Volts A TRR CJ RJL TJ,TSTG NOTES: 1.Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, Irr=0.25A 2.Measured at 1 MHz and Applied Vr=4.0 volts 2 3.8.0mm (.013mm thick) land areas S PF /W RATING AND CHARACTERISTIC CURVES S1A THRU S1M Fig. 1-FORWARD CURRENT DERATING CURVE Fig. 2-MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT Fig. 3-TYPICAL REVERSE CHARACTERISTICS Fig. 4-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS Fig. 5-TRANSIENT THERMAL IMPEDANCE Fig. 6-TYPICAL JUNCTION CAPACITANCE