HA17474/P Quad Operational Amplifier Description HA17474/P is a quad operational amplifier with provided internal frequency compensation and high performance. It can be applied widely to measuring control equipment and to general use. Features • • • • • • High speed: 1.6 V/µs Continuous short-circuit protection Low-noise operational amplifiers Internal frequency compensation Wide operating power supply voltage range: V = ±2 V to ±20 V Pin compatible with HA17324, HA17902 Ordering Information Type No. Application Package HA17474P Industrial use DP-14 HA17474 Commercial use HA17474/P Pin Arrangement Vout1 1 Vin(−)1 2 Vin(+)1 3 VCC 4 Vin(+)2 5 Vin(−)2 6 Vout2 7 14 Vout4 1 − + + 4 13 Vin(−)4 − 12 Vin(+)4 11 VEE − + 2 − + 3 10 Vin(+)3 9 Vin(−)3 8 Vout3 (Top View) Circuit Schematic VCC Vin (+) Vin (−) Vout to VCC VEE 2 HA17474/P Absolute Maximum Ratings (Ta = 25°C) Ratings Item Symbol HA17474 HA17474P HA17474RP Unit Power supply VCC +20 +20 +20 V VEE –20 –20 –20 V Vin(diff) ±30 VCM ±15 * Common-mode differential voltage Common-mode input voltage ±30 ±15 * 1 2 ±30 ±15 * 1 2 V 1 V 2 Power dissipation PT 670 * 670 * 670 * mW Operating temperature range Topr –20 to +75 –20 to +75 –20 to +75 °C Storage temperature range Tstg –55 to +125 –55 to +125 –55 to +125 °C Notes: 1. For supply voltage less than ±15 V, the absolute maximum input voltage is equal to the supply voltage. 2. Value under Ta ≤ 35°C. In case of more than it, 8.3 mW/°C derating shall be done. Electrical Characteristics (Ta = 25°C, VCC = +15 V, VEE = –15 V) Item Symbol Min Typ Max Unit Test conditions Input offset voltage VIO — 1.0 5.0 mV RS ≤ 10 kΩ Input offset current I IO — 30 50 nA Input bias current I IB — 100 300 nA Voltage gain AVD 88 94 — dB RL ≥ 2 kΩ, VO = ±10 V Maximum output Vop-p ±12 ±13.7 — V RL ≥ 10 kΩ ±10 ±12.5 — V RL ≥ 2 kΩ voltage Common-mode input voltage range VCM ±12 ±14 — V Common-mode rejection ratio CMR 80 90 — dB RS ≤ 10 kΩ Supply voltage rejection ratio PSRR — 50 100 µV/V RS ≤ 10 kΩ Power dessipation Pd — 150 210 mW 4-channel, No load Slew rate SR — 1.6 — V/µs AVD = 1 Equivalent input noise voltage VNI — 9 — nV/√Hz RS = 1 kΩ, f = 1 Hz to 1 kHz Channel separation CS — 108 — dB f = 1 kHz Note: Since these products provide a high slew rate, oscillation may occur due to load capacitance. An allowable capacitor value is minimum at voltage follower. 3 HA17474/P Package Dimensions Unit: mm 19.20 20.32 Max 8 6.30 7.40 Max 14 1.30 7 2.54 ± 0.25 0.48 ± 0.10 0.51 Min 2.39 Max 2.54 Min 5.06 Max 1 7.62 + 0.10 0.25 – 0.05 0° – 15° Hitachi Code JEDEC EIAJ Mass (reference value) 4 DP-14 Conforms Conforms 0.97 g HA17474/P Cautions 1. Hitachi neither warrants nor grants licenses of any rights of Hitachi’s or any third party’s patent, copyright, trademark, or other intellectual property rights for information contained in this document. Hitachi bears no responsibility for problems that may arise with third party’s rights, including intellectual property rights, in connection with use of the information contained in this document. 2. Products and product specifications may be subject to change without notice. Confirm that you have received the latest product standards or specifications before final design, purchase or use. 3. Hitachi makes every attempt to ensure that its products are of high quality and reliability. However, contact Hitachi’s sales office before using the product in an application that demands especially high quality and reliability or where its failure or malfunction may directly threaten human life or cause risk of bodily injury, such as aerospace, aeronautics, nuclear power, combustion control, transportation, traffic, safety equipment or medical equipment for life support. 4. Design your application so that the product is used within the ranges guaranteed by Hitachi particularly for maximum rating, operating supply voltage range, heat radiation characteristics, installation conditions and other characteristics. Hitachi bears no responsibility for failure or damage when used beyond the guaranteed ranges. Even within the guaranteed ranges, consider normally foreseeable failure rates or failure modes in semiconductor devices and employ systemic measures such as failsafes, so that the equipment incorporating Hitachi product does not cause bodily injury, fire or other consequential damage due to operation of the Hitachi product. 5. This product is not designed to be radiation resistant. 6. No one is permitted to reproduce or duplicate, in any form, the whole or part of this document without written approval from Hitachi. 7. Contact Hitachi’s sales office for any questions regarding this document or Hitachi semiconductor products. Hitachi, Ltd. Semiconductor & Integrated Circuits. Nippon Bldg., 2-6-2, Ohte-machi, Chiyoda-ku, Tokyo 100-0004, Japan Tel: Tokyo (03) 3270-2111 Fax: (03) 3270-5109 URL NorthAmerica : http:semiconductor.hitachi.com/ Europe : http://www.hitachi-eu.com/hel/ecg Asia (Singapore) : http://www.has.hitachi.com.sg/grp3/sicd/index.htm Asia (Taiwan) : http://www.hitachi.com.tw/E/Product/SICD_Frame.htm Asia (HongKong) : http://www.hitachi.com.hk/eng/bo/grp3/index.htm Japan : http://www.hitachi.co.jp/Sicd/indx.htm For further information write to: Hitachi Semiconductor (America) Inc. 179 East Tasman Drive, San Jose,CA 95134 Tel: <1> (408) 433-1990 Fax: <1>(408) 433-0223 Hitachi Europe GmbH Electronic components Group Dornacher Straβe 3 D-85622 Feldkirchen, Munich Germany Tel: <49> (89) 9 9180-0 Fax: <49> (89) 9 29 30 00 Hitachi Europe Ltd. Electronic Components Group. Whitebrook Park Lower Cookham Road Maidenhead Berkshire SL6 8YA, United Kingdom Tel: <44> (1628) 585000 Fax: <44> (1628) 778322 Hitachi Asia Pte. Ltd. 16 Collyer Quay #20-00 Hitachi Tower Singapore 049318 Tel: 535-2100 Fax: 535-1533 Hitachi Asia Ltd. Taipei Branch Office 3F, Hung Kuo Building. No.167, Tun-Hwa North Road, Taipei (105) Tel: <886> (2) 2718-3666 Fax: <886> (2) 2718-8180 Hitachi Asia (Hong Kong) Ltd. Group III (Electronic Components) 7/F., North Tower, World Finance Centre, Harbour City, Canton Road, Tsim Sha Tsui, Kowloon, Hong Kong Tel: <852> (2) 735 9218 Fax: <852> (2) 730 0281 Telex: 40815 HITEC HX Copyright ' Hitachi, Ltd., 1998. All rights reserved. Printed in Japan. 5