SME1400B-10 The Communications Edge ™ Low Cost Broadband Surface Mount Mixer Product Features • RF 1 to 2200 MHz • LO 1 to 2200 MHz • IF 1 to 2000 MHz • LO Drive: +10 dBm (Other Levels Available) • No Internal Solder Connections Product Photo Specifications Parameter SSB Conversion Loss (Max) RF/LO = 10-1300 MHz, IF = 10-1000 MHz RF/LO = 10-2500 MHz, IF = 10-1000 MHz RF/LO = 1-2500 MHz, IF = 1-2000 MHz Port-to-Port Isolation (Min) L-R = 10-2000 MHz L-R = 10-2500 MHz L-I = 10-2000 MHz L-I = 10-2500 MHz R-I 3rd Order Input Intercept Point VSWR R-Port = 600-2000 MHz R-Port = 10-2500 MHz L-Port = 600-2000 MHz L-Port = 10-2500 MHz I-Port 1 dB Conversion Compression Guaranteed +25°C -40° to +70°C Units Typical dB dB dB 6.2 7.5 8.0 8.0 9.0 8.5 9.5 dB dB dB dB dB dBm 35 25 26 22 25 19 24 17 19 15 25 18 20 16 dBm 1.7:1 2.0:1 1.6:1 2.0:1 1.8:1 +6 1. Measured in a 50-ohm system with nominal LO drive of +17 dBm, low side LO, and downconverter application only, unless otherwise specified. 2. Measured at LO = 400-2100 MHz, RF = 500-2200 MHz, IF = 100 MHz, unless otherwise specified. Absolute Maximum Ratings Parameter Operating Temperature Storage Temperature RF Input Power Ordering Information Rating -40 to +70°C -65 to +100°C +23 dBm at +25°C Part No. Description SME1400B-10 Mixer (Available in tape and reel) SME1400B-10-PCB Fully Assembled Application Circuit WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: [email protected] • Web site: www.wj.com September 2000 SME1400B-10 Performance Charts IIP3 vs. LO Power IIP3 vs. Frequency 19.0 28 5 IF = 100 MHz IF = 300 MHz 26 RF1 = 2000 MHz IF = 100 MHz 22 20 IF = 10 MHz 18 LO = 100 MHz 18.0 17.5 17.0 0 500 1000 1500 2000 8 9 10 11 12 FL< F R 2000 2500 3000 Conversion Loss vs. LO Power Conversion Loss vs. Temperature 6.4 Conversion Loss (dB) RF = 900 MHz 6.5 1000 MHz 6.5 7.0 LO = 800 MHz 1 6.6 6.7 6.8 6.9 7.5 2 3 4 5 6 7 8 7 8 9 10 11 12 7.0 -40 13 -20 0 20 40 60 RF Power (dBm) LO Power (dBm) Temperature ( C) ° VSWR vs. Frequency IF VSWR vs. Frequency Isolation vs. Frequency 1.0 1.0 1.2 1.2 1.6 45 Isolation (dB) 1.4 1.6 LO = 1000 MHz VSWR RF 1.8 2.0 2.0 2.2 2.2 2.4 2.4 500 1000 1500 Frequency (MHz) 2000 2500 3000 L-R 50 LO = 500 MHz 1.4 80 55 LO 0 1500 Conversion Loss vs. RF Power 7.0 1.8 1000 Frequency (MHz) 6.5 0 500 LO Power (dBm) 6.0 7.5 0 Frequency (MHz) Conversion Loss (dB) Conversion Loss (dB) IF = 2000 MHz 9 13 1500 MHz VSWR IF = 100 MHz 8 11 7 2500 6.0 8.0 7 10 16 14 IF = 1000 MHz 6 RF2 = 2010 MHz Conversion Loss (dB) 24 18.5 Intercept Point (dBm) Intercept Point (dBm) Conversion Loss vs. Frequency 40 L-I 35 R-I 30 LO = 2000 MHz 25 20 0 500 1000 Frequency (MHz) 1500 2000 0 500 1000 1500 2000 2500 Frequency (MHz) WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: [email protected] • Web site: www.wj.com September 2000 SME1400B-10 Single-Tone IM Products Harmonics of fLO Harmonics of fRF 0 0 1 2 3 4 5 34 44 46 57 53 1 27 0 33 12 35 28 2 63 55 56 55 59 59 3 >80 69 >80 68 73 47 4 77 >80 >80 >80 >80 >80 5 >80 >80 >80 >80 >80 >80 LO Mult RF Mult LO MHz RF MHz IM Prod MHz dB 0 1 1950 2000 2000 0 2 1950 1000 2000 63 0 3 1950 700 2100 84 0 4 1950 600 2400 77 0 5 1950 400 2000 80 1 0 2000 1950 2000 34 -1 1 1950 2000 50 0 1 -2 2000 975 50 55 1 -3 2000 650 50 69 1 -4 2000 488 48 90 1 -5 2000 390 50 88 2 0 1000 1950 2000 44 27 -2 1 550 2000 900 33 2 -2 2000 1975 50 56 2 -3 2000 1317 49 89 2 -4 2000 988 48 90 2 -5 2000 790 50 89 3 0 700 1950 2100 46 -3 1 400 1550 350 12 3 -2 1500 1200 2100 55 68 3 -3 2000 1983 51 -3 4 2200 1700 200 80 3 -5 2000 1190 50 89 57 4 0 500 1950 2000 -4 1 420 2000 320 35 4 -2 800 1200 800 59 4 -3 1100 1200 800 73 4 -4 2000 1987 52 89 -4 5 2075 1700 200 88 5 0 400 1950 2000 53 -5 1 350 1950 200 28 5 -2 700 1200 1100 59 5 -3 1000 1200 1400 47 5 -4 1150 1200 950 86 5 -5 1710 1700 50 88 Test Conditions RF at -10 dBm; LO at +10 dBm RF harmonics and intermodulation products are referenced to a desired signal produced by fLO = 2000 MHz and fRF = 1950 MHz. LO harmonics are referenced to the LO drive signal. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: [email protected] • Web site: www.wj.com September 2000 SME1400B-10 Outline Drawing Land Pattern Mounting Configuration Specifications and information are subject to change without notice. Caution! ESD sensitive device. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: [email protected] • Web site: www.wj.com September 2000