SURFACE MOUNT DISPLAY KPSA56-101 HIGH EFFICIENCY RED Features ! 0.56 INCH !LOW Description DIGIT HEIGHT. The High Efficiency Red source color devices are CURRENT OPERATION. !EXCELLENT CHARACTER APPEARANCE. made with Gallium Arsenide Phosphide on Gallium Phosphide Orange Light Emitting Diode. !I.C. COMPATIBLE. !MECHANICALLY !GRAY RUGGED. FACE,WHITE SEGMENT. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAA9121 APPROVED : J. Lu REV NO: V.1 CHECKED : DATE: FEB/21/2002 DRAWN: J.X.FU PAGE: 1 OF 5 Selection Guide Par t No . KPSA56-101 Dic e Iv (m c d ) @ 10 m A L en s Ty p e HIGH EFFICIENCY RED (GaAsP/GaP) WHITE DIFFUSED D es c r i p t i o n Min . Ty p . 3 7.4 Common Anode,Rt. Hand Decimal Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par am et er λpeak Peak Wavelength High Efficiency Red λD Dominate Wavelength High Efficiency Red ∆λ1/2 D ev i c e Spectral Line Halfwidth High Efficiency Red Ty p . Un it s Tes t Co n d it io n s 6 27 nm IF=20mA 6 25 nm IF=20mA 45 nm IF=20mA pF VF=0V;f=1MHz 2.5 V IF=20mA 10 uA V R = 5V C Capacitance High Efficiency Red 15 VF Forward Voltage High Efficiency Red 2.0 IR Reverse Current High Efficiency Red Max . Absolute Maximum Ratings at T)=25°°C P ar am e t e r H i g h E f f i c i e n c y R ed Un it s Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA9121 APPROVED : J. Lu REV NO: V.1 CHECKED : DATE: FEB/21/2002 DRAWN: J.X.FU PAGE: 2 OF 5 High Efficiency Red KPSA56-101 SPEC NO: DSAA9121 APPROVED : J. Lu REV NO: V.1 CHECKED : DATE: FEB/21/2002 DRAWN: J.X.FU PAGE: 3 OF 5 KPSA56-101 SMT Reflow Soldering Instruction Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) SPEC NO: DSAA9121 APPROVED : J. Lu REV NO: V.1 CHECKED : DATE: FEB/21/2002 DRAWN: J.X.FU PAGE: 4 OF 5 Tape Specification (Units : mm) SPEC NO: DSAA9121 APPROVED : J. Lu REV NO: V.1 CHECKED : DATE: FEB/21/2002 DRAWN: J.X.FU PAGE: 5 OF 5