T-1 (3mm) SOLID STATE LAMP L-934GD-12V GREEN Features Description !LOW POWER CONSUMPTION. The Green source color devices are made with Gallium !GENERAL PURPOSE LEADS. Phosphide Green Light Emitting Diode. !RELIABLE AND RUGGED. !LONG LIFE - SOLID STATE RELIABILITY. ! AVAILABLE ON TAPE AND REEL. !12V INTERNAL RESISTOR. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. D i g i t a l l y s i SPEC NO: DSAA5342 APPROVED : J. Lu REV NO: V.3 CHECKED :Allen Liu DATE:MAR/15/2003 DRAWN:S.J.HOU PAGE: 1 OF 3 Selection Guide Par t No . Di c e L-934GD-12V Iv (mc d ) V=12V L en s Ty p e GREEN (GaP) GREEN DIFFUSED View in g An g l e Min . Ty p . 2θ1/2 8 20 60° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.. Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par ameter Dev ic e λpeak Peak Wavelength Green λD Dominate Wavelength ∆λ1/2 Ty p . Max . Un i t s Tes t Co n d itio n s 565 nm V F =12V Green 568 nm V F =12V Spectral Line Half-width Green 30 nm V F =12V IF Forward Current Green 8.5 11.5 mA V F =12V IR Reverse Current Green 10 uA V R=5V Absolute Maximum Ratings at T)=25°°C Par ameter Gr een Un i t s Power dissipation 120 mW Forward voltage 14 V Reverse voltage 5 V OperatingTemperature -40 °C To +70 °C Storage Temperature -40 °C To +85 °C 260°C For 5 Seconds Lead Solder Temperature [1] Note: 1. 2mm below package base. SPEC NO: DSAA5342 APPROVED : J. Lu REV NO: V.3 CHECKED :Allen Liu DATE:MAR/15/2003 DRAWN:S.J.HOU PAGE: 2 OF 3 Green L-934GD-12V SPEC NO: DSAA5342 APPROVED : J. Lu REV NO: V.3 CHECKED :Allen Liu DATE:MAR/15/2003 DRAWN:S.J.HOU PAGE: 3 OF 3